1.
The analysing and calculation of the measurement of cam lift rang effected by the cam base circle eccentricity
凸轮基圆偏心影响凸轮升程测量的分析与计算
2.
The Fitting of the Measured Cam Lift Data by Optimization Method
用最优化方法计算拟合实测配气凸轮升程数据
3.
A New Non-Contact Measuring Method for the Raising Error of the Cam Curves;
一种凸轮升程误差的非接触式测量新方法
4.
A universal mathematical model and its experimental research on cam lift conversion
凸轮升程转换通用数学模型与试验研究
5.
The effects on engine cam lift curve by different smoothing method have been compared.
比较了不同光版方法对发动机配气凸轮升程曲线拟合的影响。
6.
The coefficients of 8 items were ascertained with the boundary conditions of the moves of valve and plunger.
本文给出八个独立的边界条件，从而确立了凸轮升程函数为八项式。
7.
Optimum Design of Disk Cam Mechanisms with Rectiliner Translation Roller Follower for Maximum Efficiency of Lift Travel
按升程效率最佳优化设计直动从动件凸轮机构
8.
Some optimum fitting methods for treating the measured lift data of the symmetrical cam profile are presented in the previous decades.
已有的配气凸轮实测升程数据的优化拟合研究基本上都是针对对称型配气凸轮展开的。
9.
a massive power hammer; raised by a cam until released to fall under gravity.
一种大动力锤；通过凸轮提升在重力作用下释放。
10.
A study of cam profile equations and engagement features for cam mechanisms with planar envelope and globoidal indexing
平面包络弧面分度凸轮机构凸轮廓面方程与啮合特性的研究
11.
The Profile Determination of Conical Cam with a Translating Follower Based on the Theory of Envelopes
应用包络面理论建立直动从动件圆锥凸轮机构凸轮廓面方程
12.
overhead cam shaft
上凸轮轴上部凸轮轴
13.
A computer graphics program of cam design is presented.
本文介绍凸轮设计的计算机绘图程序。
14.
program cam contact
程序鼓凸轮接点-卡片穿孔机上的
15.
Fundamental Equation for Cam Mechanisms-from Planar to Spherical
凸轮机构的基本方程:从平面到球面
16.
A DISCUSSION ABOUT POLAR COORDINATE EQUATION OF DISC CAM OUTLINE
关于盘形凸轮廓线极坐标方程的讨论
17.
The General Equations of Roller Follower Disc Cam Contour Line
滚子从动件盘形凸轮廓线的通用方程
18.
CAD for Globular Indexing Cam Mechanism on Base of Reverse Engineering;
基于逆向工程的弧面分度凸轮机构CAD