1.
Study on Simulation of Flow Channel Design in Manufacturing Typical Plane and Surface Parts by Using VARI Process
VARI工艺制备典型平面及曲面构件的流道设计模拟研究
2.
B-spline Curve and Surface Reconstruction under Geometric Constraint;
几何约束条件下的B样条曲线曲面重构
3.
The Construction Design of the Bending Die for Improving the Surface Finish of Parts;
提高工件表面质量的弯曲模结构设计
4.
Rebuilding of Freeform Surface with Industrial Design Software;
工业设计软件中的自由曲面重构解析
5.
Surface Reconstruction and Accuracy Improvement of Typical Automobile Covering Panel
汽车典型覆盖件曲面重构及精度提高
6.
The Reverse Surface Reconstruction Technology of Plastics with Complexity Surface Base on UGNX
基于UGNX的复杂曲面塑件逆向重构技术
7.
3-D Surface Reconstruction of Irregular Industrial Sheetmetal Parts Based on Structure Illumination;
基于结构光的不规则工业钣金件三维曲面重建
8.
Surface Reconstruction of the Typical Auto Panel and the Analysis of Defect in Forming Process;
汽车典型覆盖件曲面重构及成形过程缺陷分析
9.
Study on the Method of Complicated Curved-surface Parts 3D CAD Mold Building;
复杂曲面零件三维CAD模型构造方法的研究
10.
The Research and Software Development of Three-Dimensional Surface Modeling and Editing;
三维曲面构造及编辑技术的研究与软件开发
11.
Discussions on Conditions of Plane Hinge Four-bar Mechanism with Crank;
平面铰链四杆机构具有曲柄的条件推导及讨论
12.
Analysis of the Dangerous Sectionin Tangent Bend Deformation;
关于双向弯曲变形构件危险截面的讨论
13.
Study on Concrete Compressive Strength Curve of Member Bottom Surface Detected by Rebound Method
回弹法检测构件底面混凝土抗压强度曲线研究
14.
Buckling Analysis of Thin-Walled Sections Under General Loading Conditions
普通荷载作用下的薄壁构件截面屈曲分析
15.
Application of M-N correlation curves to the calculation of a section of lightweight aggregate concrete circular section members under eccentric loads
M-N相关曲线用于轻骨料混凝土圆形截面偏压构件截面的计算
16.
The Full and Essential Condition of a Ruled Surface Being a Developable Surface
直纹曲面是可展曲面的一个充要条件
17.
the curve structure and projective structure of the normal quadric surface;
常态二次曲面的曲线结构和射影结构
18.
The software of RE in data process, cure restructure are also discussed.
阐明了在软件设计中有关数据处理和曲面重构的功能。