1.
Model Selection of Large Current Enclosed Bus-bar for Nuclear Power Unit
核电机组大电流离相封闭母线的选型
2.
Comparison of Common Deaerators and Analysis on Overpressure Problem
核电机组除氧器对比与超压问题分析
3.
Installation of AP1000 PWR NPP Steam Generator
AP1000核电机组蒸汽发生器的安装
4.
MW-Class Nuclear Power Turbine Features and Its Model Selection Principles
百万千瓦级核电机组汽轮机的特点及选型原则
5.
The Advanced Strategic Study of Fuel Management for 4×650MW Units of Qinshan Nuclear Power Plant Phase Ⅱ;
秦山第二核电厂4×650MW核电机组先进燃料管理策略研究
6.
Analysis and Solutions of Existing Acceleration Protection Problems in 900 MW Unit of Daya Bay Nuclear Power Station
大亚湾核电站900MW核电机组超加速度保护存在的问题分析及对策
7.
Study and Develop on Advanced Nuclear Power Plant Expert Evaluation System;
先进核电机组专家评价系统研究与开发
8.
A Matrix Analytic Method for the Second Loop Thermodynamic System of a Pressurized Water Reactor-based Nuclear Power Plant
压水堆核电机组二回路热力系统矩阵分析法
9.
Research on unified models of heat-economic analysis for PWR nuclear power plants
压水堆核电机组二回路热力系统热经济性分析统一模型的研究
10.
STUDY ON COMPUTATIONAL MODELS OF SECONDARY SOURCE TERMS FOR NORMAL OPERATION OF CPR1000 NUCLEAR POWER PLANTS
CPR1000核电机组二回路系统稳态运行期间的放射性源项计算
11.
Graphical modeling for simulation of average temperature control systems for nuclear units' reactors
核电机组反应堆平均温度控制仿真系统图形化建模
12.
Performance Acceptance Test for Unit No.2 of Bainian Power Development Co.
百年电力公司2号机组性能考核试验
13.
3000 kW grade AAC emergency diesel-generator for nuclear power plant
3000kW核电站AAC级应急柴油发电机组的研制
14.
PS: For Turbine/ Generator drives, check peak torque capacity.
注：对于透平或发电机组，核对峰值扭矩能力。
15.
The Green Cost Accounting and Environmental Benefit Evaluation of the Thermopower Plant;
火电机组绿色成本核算及环境效益评价
16.
Research of Operational Parameter Performance Evaluation System of 300MW Unit of Qin Huangdao Power Plant;
秦皇岛电厂300MW机组运行参数考核系统的研究
17.
CALCULATION AND CHECK SYSTEM DESIGN OF WIND TURBINE BOLT STRENGTH
风力发电机组螺栓强度计算校核系统设计
18.
Aseismatic Analysis and Parameter Optimization of Pedestal about Nuclear Engineering Gear Pumps Unit;
核电工程用齿轮泵机组底座的抗震分析及参数优化