1.
Research of Key Technology on Tolerance Measurement for Foundation Material by Computer Vision
材料缺陷视觉检测及公差测量关键技术研究
2.
Discussion on the Semiparameter Measurement Model Error Variance;
半参数测量模型误差方差求解公式的探讨
3.
Discussing the teaching of Tolerance Fiding and Technology Measurement;
“公差配合与技术测量”的教学探讨
4.
photogrammetric distortion
摄影测量畸变差，畸变差
5.
Thoughts of Teaching Reform about "Tolerance and Technical Measurement";
《公差配合与技术测量》课程教学改革的思考
6.
An Examination on Teaching "Tolerance and Fit and Technical Measurement";
《公差配合与技术测量》课程的教学与改革探讨
7.
Formula of Wireless Sensor Networks Node Locationbased on Relative TimeDifference Measurement
基于相对时差测量的网络节点定位公式
8.
Analysis of slope error in measurement of pitch diameter of metric trapezoidal thread plus gauge
公制梯形螺纹塞规中径测量斜率误差分析
9.
"Tolerance and technology with the basic measurement of" Curriculum Teaching
《公差配合与技术测量基础》课程教学刍议
10.
Research for 《tolerance matching and measurement technology》 courseware in high vocational institute
高职《公差配合与测量技术》CAI课件的研制
11.
The roundness tolerance equals to the difference between max. and min. outer diam. obtained by measuring at3 or more equable parts.
②圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。
12.
The roundness tolerance equals to the difference between max.and min. outer diam.obtained by measuring at 3 or more equable parts.
圆度公差等于三等分或多等分测量所取得的最大或最小外径之差。
13.
Measurement Error in Research on the Relations between Human Resources and Firm Performance:Random Error and Systematic Error;
人力资源系统与公司绩效关系研究的测量误差:随机误差与系统误差
14.
This paper presents a way for a large accessory to measure run-out tolerance after changing primary benchmark.
介绍了一种大型零件在原基准改变后测量端面跳动公差的方法。
15.
a unit of astronomical length based on the distance from Earth at which stellar parallax is 1 second of arc; equivalent to 3.262 light years.
测量恒星距离的天文学长度单位；一秒差距等于三十万亿公里。
16.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面，定位销，夹紧顺序，孔位测量销，模拟块偏置值及公差需有标识。
17.
Exploring on the Course Teaching of 《Tolerance Control and Measurement Technology》 Based on Working Process
基于工作过程的《公差配合与测量技术》课程教学探讨
18.
enchanced error detection & correction
增量误差的探测和校正