1.
Study of Length Calculation of Three Side Welded Lap;
三面围焊搭接角焊缝长度计算的探讨
2.
Welding the welds which are stagger first, then is the straight ang long weld.
先焊错开的端焊缝，后焊直通长焊缝。
3.
Indicates concave, convex or flush welds. Increase height to fit above other weld symbol.
指示凹焊缝、凸焊缝或平焊。增加高度以配合其他焊接符号。
4.
Regression and Analysis on Metal Strength of Welding Seam of Welding Core Wine
药芯焊丝焊缝金属强度的回归与分析
5.
As for welding seams of the same heat treatment state, the hardness of welding seam area depends on different welding wires.
对于同一种热处理状态的焊缝,焊缝区的硬度取决于不同的焊丝。
6.
Transfer Behavior Study in Weld Thickness Direction of the Welding Plastic Metal in Friction Stir Welding
搅拌摩擦焊焊缝塑性金属在焊缝厚度方向的迁移行为研究
7.
"Where thickness characteristics at the joint are more important than strength, a thinner welder is possible at reduced joint strength. "
如果焊缝的厚度比强度更重要,则在降低强度条件下可使焊缝更
8.
The Temperature Control System in HF Spiral Pipe Mill
高频螺旋焊管焊缝温度的闭环控制系统
9.
The Modelling of Temperature Control by Speed in HF Welding Pipe Process and its Temperature Control System
高频直缝焊管焊接速度控温建模及控温系统
10.
Path Planning of Six Multi-joints Robots for Line Welding
六自由度机器人在焊缝焊接应用中的路径规划
11.
Research on Weld Toughness of X80 Heavy Section Pipeline Steel at Different Welding Speeds
X80厚壁管线钢不同焊接速度下焊缝韧性研究
12.
Drag onto the page to add concave, convex, or flush welds. Increase height to fit above other weld shapes.
拖到绘图页后，可以添加凹焊缝、凸焊缝或平焊。增加高度以配合其他焊接形状。
13.
The Influence of Intricate Edge of Welded Seams in Thin-walled Pressure Vessels on Strength
薄壁压力容器焊缝错边对强度的影响
14.
The Study on Ultrasonic Testing of the Laser-Welding Seam Depth of the Gear Ring;
齿轮环激光焊缝深度超声检测的研究
15.
Study on the On-line Test Technology of Weld Width in Metal Bellows;
金属膜盒焊缝宽度在线检测技术研究
16.
slot length and width of bubble cap
泡罩齿缝长度与宽度
17.
The length or measurement of such a seam.
这样的缝的长度或量度
18.
Effect of Outside Welding Groove Angle on Weld Quality of X80 Grade SSAW Pipe
外焊坡口角度对X80级螺旋埋弧焊管焊缝质量的影响