1.
Kinematic Precision Analysis on Crankshaft Neck of Compound Follow-up Turning System
曲轴连杆颈复合跟随车削系统的运动精度分析
2.
Dynamical Analysis and Optimization on Crankshaft Neck of Compound Follow-up Turning Cutter Frame
曲轴连杆颈复合跟随车削刀架的动力学分析与优化
3.
Remove piston and connecting rods from crankshaft journals.
从曲轴颈上拆下活塞和连杆。
4.
The main bearing journals fit into the cylinder block and the big end journals align with the connecting rods.
主要轴承曲颈安装在气缸体和与连杆大头末端匹配的曲颈上。
5.
Abstract: The article introduced a grinding method and principle of the journal of crankshaft connecting rod.
本文简述了一种正在兴起的曲轴连杆轴颈的磨削方法和原理。
6.
The design of a support with eccentricity for turning high-power 9 cylinders diesel engine crank pin
大型9缸柴油机曲轴连杆轴颈车削偏心扶架设计
7.
The rod-bearing cap attaches the connecting rod to the crankpin.
连杆轴瓦盖将连杆安装到曲轴销上。
8.
The throw of the crankshaft, i.e. the distance between the main journal and the big end centers, controls the length of the stroke.
曲轴的摆幅，即在主要曲颈和连杆大头末端中心之间的距离，控制着冲程的行程。
9.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
10.
Structure Optimization for Hydrostatic Supporting Bush of Crank Shaft and Rod Type Hydraulic Motor
曲轴连杆式液压马达静压支承连杆瓦结构优化
11.
The crank end of the connecting rod is sometimes called the rod "big end".
连杆的曲轴有时称为“大头”。
12.
CAE Analysis of Crankshaft and Connecting Rod Mechanism for Motorcycle Engine
摩托车发动机曲轴连杆机构的CAE分析
13.
Dynamic Simulation of Vibration Source of Crankshaft System
发动机曲轴连杆机构振动源仿真分析
14.
An Analysis of the Improvement of Piston-Con Rod-Crank-Shaft of CG125 Engine
CG125发动机活塞连杆曲轴改进分析
15.
The cap and rod have bearings which permit the crankpin to rotate freely within the rod.
轴瓦盖和连杆中有轴瓦，它允许连杆内的曲柄锁自由地转动。
16.
The piston, through the connecting rod, transfers to the crankshaft the force created by the burning fuel mixture.
活塞，通过连杆，与曲轴相连并将燃烧混合气产生的力传给曲轴。
17.
Dynamic Modeling and Analysis for Loose Joint between Crank and Linkage of Membrane Pump
隔膜泵曲轴连杆连接松动动力学建模与分析
18.
crankshaft journal face hardening machine
曲轴轴颈表面淬火机床