1.
The Micro Positive Pressure's Controlling Project of Air-Conditioning in Spray-Paint Workshop
涂装厂房空调系统的微正压控制方案
2.
Self-Tuning Control of Piezoelectric Positioning Stage
压电陶瓷工作台的自校正PID控制
3.
A Pilot Bus Voltage Rectification Method Based on Voltage Control Area;
基于电压控制区的主导节点电压校正方法
4.
The Positive Pressure Control of One Layer Basement Pressurization Air Supply System
只负担地下一层的加压送风系统正压值的控制
5.
Dynamic model of pressure positive feedback of gauge control during aluminium striproll
铝板轧制压力正反馈厚度控制的动态模型
6.
CLOSED LOOP CONTROL OF SPARK ADVANCE USING A CYLINDER PRESSURE SENSOR
使用气缸压力传感器的点火正时闭环控制系统
7.
Modeling Simulation and Compensating of AWC Hydraulic System in E2 Rolling Mill;
E2轧机AWC液压控制系统的建模仿真与校正
8.
The Steady-State Voltage Stability Analysis and Corrective Control Research of Power System;
电力系统静态电压稳定性分析与校正控制研究
9.
Design of Sinusoidal Inverter Power Supply Independently Regulating Voltage and Frequency;
电压频率独立控制的正弦逆变电源设计
10.
Investigation of High Compression Ratio and Ignition Timing Control for Gas Engine;
燃气发动机高压缩比和点火正时控制的研究
11.
The Application of Positive Feedback Digital PID Controller in Pressure Control;
正反馈数字PID在气体压力控制中的应用
12.
Control Strategy of High Accurcy Sinusoidal Vibration for the Hydraulic Shake Table
液压振动台高精度正弦振动的控制策略研究
13.
Design of a Boost AC-DC Active Power Factor Correction Controller
升压型AC-DC有源功率因数校正控制器的设计
14.
Correction and Improvement of the Setting Value of Automatic Reactive Voltage Control
电压无功自动控制装置定值的修正与改进
15.
Matrix Converter Control Strategy Under Abnormal Input Voltage
矩阵变换器在非正常输入电压下的控制策略
16.
Construction Principle and Fault Analysis of Pressurized Control System Applied on Motor in Compressor Station
电驱压缩机站电机正压通风控制系统介绍与故障分析
17.
smoke control and pressurization panel
烟气控制和增压控制板
18.
control current or voltage
控制电流或控制电压