1.
Development of beam-based alignment system using a switchable shunt resistor for HLS
合肥光源利用电阻分流法的基于束流准直系统的研制
2.
well-collimated beam
直线状注流，良好准直光束[电子束]
3.
The Research of Two Dimensional Photonic Crystal Devices Based on the Interference of Self-collimation Beams;
基于自准直光束干涉的二维光子晶体器件研究
4.
Far-Field Detection System of Laser Beams Alignment Based on Gratings Sampling and On-Axial Illumination
基于同轴照明和光栅取样的激光束准直远场监测系统
5.
collimated lihgt beam
准直光束，平行光束
6.
The Research of Maximum Penetration Capacity Calculation for Distributed Generation Basing on Fault Current Constraints;
基于短路电流约束的分布式电源准入容量计算的研究
7.
Beam Hardening Correction Method for Cone-Beam Computed Tomography Based on Registered Model Simulation
基于配准模型仿真的锥束CT射束硬化校正方法
8.
Labor Standards and FDI Inflow:A Cross-country Empirical Study;
劳工标准水平与外商直接投资流入——基于国别数据的实证研究
9.
Curve Pencil Based Intersection for Degenerated Cases of Curves
直线/NURBS曲线等基于曲线束的求交方法
10.
Power-current Hybrid Power Flow Model Based Optimal Power Flow by Interior Point Method
基于功率—电流混合潮流约束的内点法最优潮流
11.
The Research on Constraint-Based Routing Algorithm Based on MPLS Traffic Engineering;
基于MPLS流量工程的约束路由算法研究
12.
Analysis of Timing Constraints in Workflow based on Event-condition-action(ECA) Rules;
基于ECA规则的工作流时间约束分析
13.
Optical flow computation method based on HS constraint and outline condition
基于HS约束与轮廓条件的光流场计算
14.
MODELING WORKFLOW BASED ON DIGRAPH RESTRICTED BY ECA RULES
基于ECA规则约束有向图的工作流建模
15.
Our Collimation Testers are lateral-shearing interferometers that can be used to examine and adjust the collimation of laser light.
我们的剪切板准直度测量仪是用于检查和调整激光光束准直度的横向剪切干涉仪。
16.
Boundary Tracing from Irregular Points Based on Ratio of Edge Length
基于边长比约束的离散点准确边界追踪算法
17.
STATISTIC HISTOGRAMCURVES FITTING BASED ON AREA CONSTRAINT;
基于面积约束的统计直方图曲线拟合(英文)
18.
A Robust Beamforming Method based on the Direct Data Domain Algorithm
一种基于直接数据域算法的稳健波束形成方法