1.
Application of Laser Technology for Air Gap detecting on Car Linear Motor
激光技术在车辆直线电机气隙测量中的应用
2.
Research on Measurement of Dynamic Gap of Gas Turbine Based on FPGA
基于FPGA燃气轮机动态间隙测量的研究
3.
Current was the input of observer, and gap position can be got from observer.
采用电流作为观测器的输入,通过观测器得到气隙位置等状态量。
4.
measurement of fit clearance of propeller
螺旋桨轴安装间隙测量
5.
steering wheel clearance checking scale
转向盘自由间隙测量器
6.
Measure bearings for correct clearance
测量轴承以校正间隙
7.
Study on the Assessment Methods of Stator-rotor Distortion Based on Air Gap Dynamic Measurement;
基于气隙动态测量技术的定转子变形评价方法研究
8.
Measurement Technology & Frequency Spectrum Analysis of Dynamic Pressure in Tip Clearance for Unsteady Flow;
轴流压气机转子叶尖间隙非定常动态压力测量与频谱分析
9.
Partial Discharge Measurement and Analysis of Gap in Oil-Paper Insulation Model under Lightning Impulse Voltage
雷电冲击电压下油纸绝缘气隙模型的局部放电测量与分析
10.
Measurement and Simulation of Partial Discharge in Disc-void of Oil-pressboard Insulation With Electrical Degradation Process
油纸绝缘内部气隙缺陷电劣化过程中局部放电的测量与模拟
11.
Study on methods for void fraction measurement of gas-liquid two-phase flow in microgravity
气液两相流空隙率测量方法微重力环境应用研究
12.
The Determination of Porosity and Cellulose Content of Plant Fibers by Density Methods
纤维孔隙率的测量及密度法测量的纤维素含量
13.
Study on porosity log interpretation methods of gas reservoir;
天然气储层孔隙度测井解释方法研究
14.
A visual check of air gaps is sufficient, but mechanical backflow preventers have to be tested with properly calibrated gauge equipment.
尽管安装气隙足够目视观察,但是机械式防回流阀还是必须用适当量程的仪表设备进行检测。
15.
Measurement of Voltage and Creep Age Distance, Electrical Space Limits as well as Anti-electric Strength Test Voltage to Determine
工作电压的测量与爬电距离、电气间隙限值以及抗电强度试验电压的确定
16.
Measuring Outer Rotor Clearance in Housing
在机壳中测量外转子间隙
17.
New method of measuring the clearance between bush sleeves and diesel engine rod without disassembly
柴油机连杆轴瓦间隙不拆卸测量方法
18.
Experiment Research of the Tip Clearance Measurement by Digital Radiography
转子叶尖间隙辐射成像测量实验研究