1.
Research on OHC Valve System of Vehicle s Engine;
车用发动机顶置凸轮配气系统的研究
2.
The camshaft also fits inside the block, except on overhead-cam engines( OHC).
除了顶置凸轮(HC)动机以外，凸轮轴都安装在气缸体里面。
3.
These engines are known as dual overhead camshaft( DOHC) engines.
这些发动机被称为双顶置凸轮轴(OHC)动机。
4.
Since 1958, an engine with a single overhead camshaft has been used.
从1958年起，便已使用带有单顶置凸轮机的发动机。
5.
Optimization Design of Overhead Camshaft Valve Train Based on Tribology
基于摩擦学的顶置凸轮轴式配气机构改进设计
6.
In addition, when the camshaft is located over the cylinder head, the arrangement is known as an overhead camshaft( OHC) design.
另外，当凸轮轴位于汽缸盖上面时，这种方式被称为是顶置凸轮轴(HC)构。
7.
A belt typically is used on engines with overhead-cam valve trains.
皮带一般与顶置凸轮阀门传动一起被用在发动机上。
8.
Push-rod engines typically run at slower speeds and, consequently, produce less horsepower than overhead-camshaft designs of equal size.
推杆发动机一般在低速运转，从而产生比相同大小的顶置凸轮轴较少功率。
9.
New Mitsudishi 5-Valve DOHC Engine
三菱新型顶置双凸轮轴5气门发动机
10.
In this arrangement, the cam lobes push against round metal cylinders called cam follower.
在这种布置中，凸轮凸角推动凸轮挺杆。
11.
cam shaft driving gear
凸轮轴传动齿轮凸轮轴传动装置
12.
RESEARCH ON THE DYNAMIC PERFORMANCE OF MARINE DIESEL ENGINE 180 TYPE VALVE MECHANISM WITH CAM-SHAFT ON CYLINDER HEAD
船用180柴油机顶置式凸轮轴配气机构动力性能的研究
13.
cam shaft drive
凸轮轴传动凸轮轴传动装置
14.
overhead camshaft engine
上置式凸轮轴发动机
15.
cam shaft reversing lock
凸轮轴换向闭锁装置
16.
As the camshaft rotates, the lobe, or high spot of the cam, pushes against parts connected to the stem of the valve.
当凸轮轴旋转时，凸轮凸起的或者高点的位置，推动气门座。
17.
As the camshaft continues to rotate, the high spot moves way from the valve mechanism.
因为凸轮轴继续旋转，凸轮轴上的凸起部分离开气门装置。
18.
THE ANALYSIS AND DESIGN OF AN INSIDE CONJUGATE CAM SHEDDING MECHANISM
内置式共轭凸轮开口机构分析与设计