1.
Pressure Setting of Press-keeping Clamping Circuit Based on Accumulator
基于蓄能器保压夹紧回路的压力设定
2.
Now select the Eraser tool, choosing a medium sized soft brush and with the pressure set to approximately 30%.
现在选择橡皮擦工具，选择一个中等大小的软刷，并与压力设定约30％。
3.
Design of High-pressure Packing Seal for Pressure Sensor Calibration Device
压力传感器标定装置高压密封垫的设计
4.
Check the nitrogen pressure regularly, see the" accumulator instructions" below, and regarding charging equipement.
定期检查氮气压力，参阅下方的“储能器操作“，定期检查充压设备。
5.
42LE PRESSURE PORT LOCATIONS
４２ＬＥ压力端口定位
6.
Simple and accurate settings of cutting depth and free settings for back stroke of pressure plate to reduve the idle motion and improve working efficiency.
裁力深度设定简单、准确、压板回程可任意设定，减少空行程，提高工效。
7.
DOT design pressure
美国运输部规定的容器最大允许设计压力
8.
Die Design of Locating Safety Block of Electric Assistant Redirector of Automobile;
汽车电动助力转向器定位保险块压铸模设计
9.
Design and implementation of fully automatic calibration system for pressure gauges with pointers
指针式压力表自动检定系统的设计与实现
10.
Research on Design of Critical External Compressive Resistance of Buckling of Stiffener Ring of Underground Penstock
埋藏式压力钢管加劲环抗外压稳定设计的改进研究
11.
PRESSURE/ TEMPERATURE RATINGS FOR BRONZE PRESSURE RATED VALVES?
青铜额定压力阀门的压力／度额定值?
12.
PRESSURE/TEMPERATURE RATINGS FOR BRONZE PRESSURE RATED VALVES?
青铜额定压力阀门的压力／温度额定值?
13.
Some suggestions were proposed to the calculation of earth pressure in gravity retaining wall design.
对重力式挡土墙设计中土压力的计算具有一定参考价值。
14.
Almost all equipment connected to a power system is designed to be used at a certain definite voltage.
几乎所有与电力系统联接的设备都设计在某一固定电压下使用。
15.
Click on Shape dynamics and set the ‘Size Jitter slider to zero and the control to ‘Pen Pressure.
点击动力学形态，设定“混合大小”在滑块上设置0，用笔刷压感控制。
16.
normal pressure and temperature
额定压力及温度正常压力和温度
17.
Application of Pressure Testing During Pressure Vessel Safety Assessment
压力容器安全评定中压力试验的应用
18.
Sectional specification for power transformers for switched mode power supplies (SMPS) for use in electronic equipment for capability approval
GB/T15184-1994按能力批准评定质量的电子设备用开关电源变压器分规范