1.
Stability of Flow in Microchannels of Environmental Monitoring Chip;
环境监测芯片内微槽道流动稳定性研究
2.
The Influence of Variable Fluid Properties and Polymers on Flow and Heat Transfer Characteristics in a Turbulent Channel Flow
流体变物性和添加高聚物对湍流槽道流动与传热特性的影响
3.
Simulation of Surface Roughness and Processing Fault Effects on Microchannel Flows;
壁面粗糙度和加工缺陷对微槽道流动的影响模拟
4.
Investigation on Heat Transfer and Flow Performance of Rectangle Channel with Riblets Groove;
矩形条纹槽道传热和流动特性的研究
5.
Investigation on Heat Transfer and Flow Performance of Rectangle Channel with Active Control;
矩形槽道主动控制传热和流动特性的研究
6.
Electro-osmotic Flows in Micro Irregular Channels;
微小异形截面槽道内电渗流动特性分析
7.
Visualization and Analysis on Flow Boiling in Microgroove;
微槽道内流动沸腾可视化实验研究与分析
8.
Experimental Investigation on Turbulence Modification in a Horizontal Channel at Relatively Low Mass Loadings;
水平槽道内低颗粒载荷下湍流变动的实验研究
9.
One-Dimensional Spectral Analysis of Drag Reduction with Spanwise-Wall Osillation in Channel Flow
槽道流壁面展向周期振动减阻的一维谱分析
10.
Notch filter feedback control for chaotic motion of fluid conveying pipe
输流管道混沌运动的凹槽滤波反馈控制研究
11.
The turbulent flow in a straight channel was numerically simulated with LES of algebraic modelling.
该模型首先用于直槽道内的湍流运动的数值模拟。
12.
Measurement of Turbulence in a Particle-laden Channel Flow Using PIV Technique;
水平槽道内湍流两相流的PIV测量
13.
Study of axial flow velocity in axially stirred tank
轴流桨搅拌槽内轴向流动速度的研究
14.
The molten metal channels into a belt of troughs
熔化的金属流入了槽管道里。
15.
Study on the Fluid Flow Plate with Humidify Channel for PEMFC;
PEMFC带增湿槽道集流板的研究
16.
Research on the Two-phase Flow with Cylindrical and Cubic Particles in the Channel and Pipe Flows
槽道和圆管中柱状粒子两相流的研究
17.
Application of Cut_throat Flume in Intelligent Flow Sensor
无喉道槽在智能流量传感器中的应用
18.
"Chute: an inclined trough, passage, or channel through or down which things may pass."
倾斜的水槽、通道或管道,可以让东西流过.