1.
The Fuzzy Reliability Calculation for Cylinder Liner Wear of Internal Combustion Engine Based on the Grey Forecasting
基于灰色预测的内燃机气缸套磨损模糊可靠性计算
2.
Study of surface strengthening technology and wear test of diesel engine cylinder liner
柴油机气缸套表面强化工艺及磨损试验的研究
3.
Research on Detection Methods of Abrasion on the Surface of Cylinder Liner Based on Image Processing Technology;
基于图像处理技术的气缸套表面磨损检测方法研究
4.
EXPERIMENTAL STUDY OF ABRASIVE-CORROSIVE WEAR OF MUD PUMP LINER
钻井泵缸套材料磨料—腐蚀磨损实验研究
5.
The Theoretical Study of Cylinder Liner's Lubrication Model after Laser Honing;
激光珩磨气缸套润滑模型的理论研究
6.
Measures taken to prevent abrasion of the plunger in cylinder sleeve of a cryopump and to improve sealing performance
低温泵缸套柱塞防磨损和提高密封性的措施
7.
The Best Experiment Program of Cylinder Wears by Means of the Orthogonal Test
用正交试验法研究汽缸套磨损试验的最优方案
8.
A Study on Equipment of Intelligent Capacitance Measuring Wear of Cylinder Bore of Auto Engine
智能型电容式发动机缸套磨损测量仪的研究
9.
Research on simulation experiment method of piston ring and cylinder friction and wearing;
内燃机活塞环—缸套摩擦磨损实验方法的研究
10.
The Application of Neural Network Technique in the Research on Wear of the Cylinder;
神经网络技术在缸套磨损研究中的应用
11.
The Integration of Cylinder Liner-Piston Ring Wear and Lubrication in Lnternal Combustion Engine
内燃机中缸套-活塞环的磨损与润滑综述
12.
Study on Synthetical Evaluating Methods of Running-in & Wearing Surface Quality of Marine Diesel Cylinder Liner;
船舶柴油机缸套材料磨合磨损表面质量综合评价方法的研究
13.
Research on Friction and Wear Characteristic of Cylinder Liner-Piston Ring for Diesel Engine in Running-in Period Based on Fractal Theory;
基于分形理论的柴油机缸套—活塞环磨合期摩擦磨损特性研究
14.
Research on the Wear Resistance of Micro-structure of Alloy-cast-iron Cylinders and Wear Mechanism Analysis;
合金铸铁缸套微观组织耐磨性研究及磨损机理分析
15.
Analysis of the Cause for Early Stage Single-Direction Cylinder Wear of 6135 Diesel Engines
6135柴油机初期气缸单向磨损的原因分析
16.
Non-disassembly measurement method on wear values for turbine-engine cylinders
内燃机气缸磨损量不解体检测方法的研究
17.
Reasons for Cracks in Cylinder Liner of Engine for Driving Water Pump for Blowing Sand
驱动吹沙水泵柴油机气缸套裂纹损伤原因分析
18.
"If wear is too great to be taken care of by honing alone, cylinders must be Bored first and them Boned."
如果磨损严重,仅靠衍磨不能解决问题,那么气缸必须先进行镗削,然后再衍磨。