1.
Aero hydraulic pressure accessory displacement measurement device based on linear CCD
基于CCD线阵的航空液压附件位移测量装置
2.
Development of Large Single-piece Forgings and Heavy Forging Presses in Aerospace Forging Industry
大型模锻件和模锻液压机与航空锻压技术
3.
rmail correspondence
免收航空附加费的航空函件
4.
Annex 4: Agreement on Trade in Civil Aircraft
附件4： 《民用航空器贸易协定》
5.
Research on Test System of Aviation Hydraulic Valve s Contamination Sensitivity;
航空液压阀污染敏感度测试系统研制
6.
Finite element analysis of 400 MN aviation die forging hydraulic press frame
400MN航空模锻液压机机架有限元分析
7.
The Discussion on the Automatic Survey System in Aerial Hydraulic Pressure Oil Pumping Vehicle
航空液压油泵车自动检测系统的设计
8.
Pneumatic and/ or hydraulic unit repair experience is preferred.
气动和/液压附件修理工作经验优先。
9.
Pneumatic and/or hydraulic unit repair experience is preferred.
气动和/或液压附件修理工作经验优先。
10.
Experience with automtoive/aeronautical hydraulics hardware (plumbing, valving, transducers, etc.) If at all possible this person should understand hydraulics and how DA systems that collect data from hydraulic systems as much as possible.
有汽车或航空业液压硬件相关工作经验（如管道工程，阀门装设或传感器配置等）。
11.
Research and Design for Aero-Engine High-Speed Accesory Transmission System;
航空发动机高速附件传动系统研究和设计
12.
Application of Automatic Particle Counting Method in Aeroengine Fuel Pump
自动颗粒计数法在航空燃油附件中的应用
13.
Simulation on hydromechanical controller of modern aero-engine
现代航空发动机液压机械控制器仿真研究
14.
Design of Helicopter Hydraulic Component Test Bed;
某型直升机液压附件综合测试台的设计
15.
Improvement of Fatigue Strength of High Strength Aerospace Fastener by Using Rolling
滚压加工技术提高高强航空紧固件的疲劳强度
16.
FEM Analysis of Deformation Correction by Side-wall Rolling of Aircraft Monolithic Components
航空整体结构件侧壁滚压校正的有限元分析
17.
The Hydraulic Fountain Subassembly Manufacture of Some air-air Missile Ground Control and Measure System;
某空空导弹地面检测系统液压源组件研制
18.
Of, relating to, or for use with air mail.
航空邮件的航空邮件的，与航空邮件有关的，利用航空邮件的