1.
Except form ties bolt, lateral bracing should set up for supporting that has three lines which is up, medium and down.
11除对拉螺栓外，设置辅助侧向支撑进行支顶，上中下三道。
2.
Wall form installation please see attached sketch No.-4. Expended cement mortar shall be used for sealing after form dismantled and pull bolts removed.
墙板模板安装见附图4。在模板拆除对拉螺栓拿出后，采用微膨胀水泥砂浆封堵。
3.
tightening bolt
拉紧螺栓，(铁)风口拉杆
4.
LOWER TRACK BAR BOLT INSTALLATION
下横拉杆螺栓的安装
5.
Hold puller screw and tighten puller nut until bushing is remove
握紧拉拔器螺栓，拧紧拉拔器螺母，直至拆下衬套。
6.
"Bolts,screws & nuts"
"螺栓,螺丝及螺帽"
7.
Tie Rod End To Steering Knuckle Nut
转向拉杆端与转向关节螺栓
8.
Tie Rod End Adjusting Sleeve Nut
转向拉杆端调整轴筒螺栓
9.
Study on tension and block shear behavior of bolted single angle-gusset plates
单角钢螺栓连接节点板拉剪性能研究
10.
Design of Tensile Testing Device for Small Diameter Bolt and Screw
小直径螺栓和螺钉拉伸试验装置的设计
11.
Application of The bolt stretcher in tightening and disassembling polymer filter
螺栓预拉伸法在聚酯熔体过滤器螺栓装拆作业中的应用
12.
Research on the Influences of Internal Oblique Nut on Bolt Bearing Capacity
内斜螺母对螺栓承载能力影响的研究
13.
Position lever assembly on floorpan and install lever mounting bolts.
将拉杆组合放置到底板上并安装拉杆固定螺栓。
14.
Improved construction method of expansion bolt and annectent reinforcing bar in shell frame filled-wall
填充墙拉结筋膨胀螺栓施工方法的改进
15.
The Finite Element Method and Experimental Analysis of High Strength Bolted Connections;
高强度螺栓抗拉连接的仿真及实验研究
16.
AN INVESTIGATION ON THE TENSION ANALYTICAL MODEL OF STEEL PLATE WITH STAGGERED BOLT HOLES
交错孔洞平板螺栓连接受拉分析模型研究
17.
Influence of nut thread shape and screwing length on bolt root stress;
螺母牙形及旋合长度对螺栓牙根部应力的影响
18.
Remove the nut and bolt attaching the track bar to the track bar mount on the body of the vehiclRemove the track bar from the track bar mount.
拆卸接合横拉杆与位于车身之横拉杆固定座的螺帽与螺栓。将横拉杆自横拉杆固定座拆卸下来。