1.
New Progress in the Cam Design of Supercharged Diesel Engine Fuel Injection Pumps
增压柴油机喷油泵凸轮设计的新进展
2.
The Design and Research Works on Increasing the Fatigue Life of the Fuel Injection Pump Cam for High Rated Diesel Engines
提高高强化柴油机喷油泵凸轮疲劳寿命的设计研究
3.
Research on the Motion Equation of Driven link Based on Fuel Injection Pump Cam Curve;
基于喷油泵凸轮廓线建立从动件运动方程的研究
4.
camshaft fuel injection pump
凸轮轴式燃油喷射泵
5.
OIL PUMP AND DISTRIBUTOR DRIVE GEAR INTEGRAL WITH CAMSHAFT
油泵及与凸轮轴集成的分电盘驱动齿轮
6.
Investigation on Decelerating Fuel Injection Pump Cam Used in the Compound Combustion System of Diesel Engine
复合式燃烧系统采用降速油泵凸轮的试验研究
7.
"But in the case of the diesel engine the supply is effected by an injection or "jerk"pump which forces a "shot"of fuel into each cylinder in turn ac cording to the correct firing sequence."
而柴油机是由喷油泵或脉动泵按照正确的点火顺序将燃油轮流地喷人各气缸的。
8.
"In addition, the camshaft has an eccentric to operate the fuel pump and a gear to drive the ignition distributor and oil pump."
此外,凸轮轴还带动一个驱动燃料泵的偏心轮和一个带动分电器和油泵的齿轮。
9.
Development of Dynamic-torque Measure System Based on the Cam-turn-angle of Diesel Fuel Pump
基于凸轮轴转角的油泵瞬态扭矩检测系统的研制
10.
Calibration fluid for diesel injection pump
GB/T8029-1987柴油机喷油泵校泵油
11.
guide piston complement for fuel pump
喷油泵导向活塞总成
12.
screw-mounted fuel injection pump
螺纹安装燃油喷射泵
13.
side-mounted fuel injection pump
侧向安装燃油喷射泵
14.
transmission of an injection pump
燃油喷射泵传动装置
15.
high flanged-mounted fuel injection pump
上部安装燃油喷射泵
16.
Drive shaft fuel injection pump
驱动轴式燃油喷射泵
17.
cradle mounted injection pump
框架安装式燃油喷射泵
18.
cradle mounted fuel injection pump
弧形底安装式喷油泵