1.
Treatment on oil throw fault in lower guide bearing of generator of Shuibuya Hydropower Plant
水布垭水电站发电机下导轴承甩油问题处置
2.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
3.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
4.
Direct Solution Method for Load Force and Jacobi Matrix of Water Guide Bearing in Turbulent Regime
湍流工况下水导轴承承载力及其Jacobi矩阵的一维直接算法
5.
The carriage is supported on guide shafts.
托架支承在导轴上。
6.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
7.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
8.
Lightly lubricate pilot bearing with Mopar® high temperature bearing grease.
用Mopar®高温轴承黄油轻轻地润滑引导轴承。
9.
alignment of bottom casing and bearing seating
下汽缸和轴承座找正
10.
low bearing oil pressure alarm
轴承油压下降警报器
11.
governor bottom bush
调速器下部轴承衬套
12.
radial bearing lower drive sub
下部径向轴承传动接头
13.
The influence of the journal misalignment in bearing bore resulted from crankshaft deformation when it acted by load should be considered in the lubrication analysis of crankshaft bearing.
曲轴轴承的润滑分析应该考虑曲轴受载变形导致轴颈在轴承孔中倾斜的影响；
14.
Welds repair of the bush of water flowing diversion bearing of the hydro-generator unit
水轮发电机组水导轴承轴瓦的焊接修复
15.
The Determination of the Critical Technical Supply Pressure of the Rubber Guide Bearing of the Axial Pump
轴流泵橡胶导轴承技术供水临界压力的确定
16.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
17.
As lubricated with outside clean water, bearings are of long life.
导轴承由外接清洁水润滑，使用寿命长。
18.
Dynamic Coefficients of Tilting Pad Guide Bea-rings of Hydraulic Turbine Sets, Power Engineering
水电机组可倾瓦导轴承动力特性系数