1.
Research of the Oil-Immersed Transformer Windings Temperature Measurement on Line;
油浸式变压器绕组温度在线测量的研究
2.
The Study of Temperature Field of No-Encapsulated-Winding Dry-Type Power Transformer and Its Structural Optimization;
非包封干式变压器绕组温度场研究及结构优化
3.
Two Dimensional Simulation Analysis of Winding Temperature Field of Oil-Immersed Power Transformer
油浸式电力变压器绕组温度场的二维仿真分析
4.
During and after each test, the temperature of the windings shall not exceed the values specified in table8.
在每一次试验期间和之后,绕组温度不应超过表8中的规定值。
5.
"Should the motor winding temperature rise excessively, the thermostats will open before the temperature can reach a level that can cause damage to the motor."
一旦电机绕组温度升得过高,并可能达到会对电机产生损坏之前,温控器将自动开启。
6.
Modeling and Application of Internal Nonsteady-state Temperature on the Coil Winding
绕组内部非稳态温度场建模及其应用
7.
Improved Method for Calculation of Hot-spot Temperature in Power Transformer
改进的变压器绕组热点温度估算方法
8.
The Study of the Eddy Losses and Temperature Field of Winding in Power Transformer;
电力变压器绕组中的涡流损耗及其温度场研究
9.
Thermal Model for Hot Spot Temperature Calculation in Oil-immersed Transformers
油浸式变压器绕组热点温度计算的热路模型
10.
CaIcuIation and Analysjs of Short Circuit Strength,Temperature RiSe and EIectric FieId in Windings of Power TranSformer
电力变压器绕组短路强度、温升、电场计算与分析
11.
The FBG Monitoring Principle of Transformer Internal Temperature and the Improved Method for Calculation of the Hot-Spot Temperature
变压器内部温度光纤传感监测及绕组热点温度计算改进方法
12.
Evaluation on the Uncertainty of Temperature of Inductive Ballast Winding in Luminairs Heat-testing
电感镇流器绕组在灯具热试验中温度的不确定度评定
13.
This paper presents a new-type instrument for on-line monitoring the coiling hot-point temperature of an oil-immersed transformer.
本文介绍了一种新型油浸式电力变压器绕组热点温度在线监测仪。
14.
Enamelled round winding wires--Part 6: Polyamide enamelled round copper wires with a temperature index of 220
GB/T6109.6-1988漆包圆绕组线第6部分:温度指数220的聚酰亚胺漆包圆铜线
15.
Enamelled round winding wires--Part 5: Polyesterimide enamelled round copper wires with a temperature index of 180
GB/T6109.5-1988漆包圆绕组线第5部分:温度指数180的聚酯亚胺漆包圆铜线
16.
Study on the Temperature Controlled System of Motor Stator Coils after the Paint Drying Craft;
电机定子绕组浸漆后烘干工艺的温度控制系统的研究
17.
Simulation and Analysis of 3D Temperature Field for Stator Winding Short-circuit in Asynchronous Motor
异步电动机定子绕组匝间短路三维温度场计算与分析
18.
Discussion on Proficiency Testing Process of Copper Winding Temperature-Rising Test
铜质绕组温升试验能力验证过程讨论