1.
Multi-rigid-body Dynamic Simulation of the Bending Roller Unit of Direct-driving Stretcher Leveller
直接传动型拉伸弯曲矫直机弯曲辊系多刚体动力学仿真研究
2.
The Accident Analysis and Transformation Study on the Stretcher Straightener;
拉伸弯曲矫正机设备故障分析及改造研究
3.
The strip deformation of simulation model established in tension levelling
带材拉伸弯曲矫直变形仿真模型的建立
4.
Application of Profibus Technology in Tension-Bending Straightening Machine
Profibus控制技术在拉伸弯曲矫直机组中的应用
5.
The Research on Strip of Tension Leveling Theory and Simulation Based on Improved the Shape;
基于改善板形的带材拉伸弯曲矫直理论研究及其仿真
6.
Study on Aided-Design of the Tension Leveling of Metal Strip and Its Control Simulation;
拉伸弯曲矫直机辅助设计与控制仿真系统的研究与开发
7.
Study on Process Parameter for the Tension Leveling of Metal Strip with the Finite Element Method;
基于有限元方法的金属带材连续拉伸弯曲矫直工艺参数研究
8.
The Tension leveller is used to improve strip shape and mechanical properties.
本机组采用拉伸弯曲矫直机的主要用途是改善镀锌带材板形及机械性能。
9.
"The leveller consists of straightener, tension rolls and driving device, basement and speedy roll change device. "
拉伸弯曲矫直机由矫直机、张力辊及其传动装置、底座和快速换辊装置部分组成。
10.
To release(a bow, for example)from flexure or tension.
伸直放开弯曲或拉紧的（如，弓）
11.
act of stretching or straightening out a flexed limb.
拉伸或矫正一个弯曲的肢体。
12.
knee joint flexion and extension exerciser
膝关节弯曲伸长训练器
13.
This series pressing machine can be widely used in the technologies of drilling, losing materials, cutting, bending, shaping and light extension etc.
本系列压力机可广泛应用于冲孔、落料、切断、弯曲、成形、浅拉伸等工艺。
14.
The simulative results show that stress distribution under stretching with superimposed bending is more advantageous to the reduction of spring back.
计算结果表明，先弯曲再拉伸时应力分布规律更利于减小回弹。
15.
Plasticity in the suppression techniques such as stamping, bending, flanging, such as tensile plate.
适用于可塑性的压制工艺，如冲压、弯曲、翻边、薄板拉伸等。
16.
The results showed that the tensile strength, flexural strength and flexural modulus increased obviously with increase of amount of Mica.
结果表明,复合材料的拉伸强度、曲强度和弯曲模量随着云母用量的增加而提高。
17.
Eular crippling stress
（纵向弯曲）欧拉临界应力
18.
Profile design for stretch bending die of extrusions considering springback
考虑弯曲回弹的拉弯模外形设计方法