1.
Simultaneous Optimization of Fixture Layout and the Application Sequences and Analysis of Stability;
夹紧顺序与夹具布局的同步优化及稳定性分析
2.
The Simultaneous Optimization of Fixture Layout and the Clamping Sequences for Weak Stiffness Workpiece
弱刚度工件夹紧顺序与夹具布局的同步优化
3.
Each datum, location pins, the number of the clamp sequence, check pin's name, the value of gap and tolerance need mark on checking fixture.
定位面，定位销，夹紧顺序，孔位测量销，模拟块偏置值及公差需有标识。
4.
hydromatic welder
水力导向焊条顺序夹持多点电焊机
5.
immediately following in time or order.
在时间或者顺序上紧随其后。
6.
Engine Cylinder Head Bolt Tightening Sequence
引擎汽缸头螺栓锁紧顺序
7.
Other pictures follow in rapid succession.
其他画面紧跟着迅速按顺序出现。
8.
A container, such as a cabinet or folder, for keeping papers in order.
文件夹按顺序放置文件的容器，如档案柜或文件夹
9.
Sorts items alphabetically by name of the folder they are in.
将项目按其所在文件夹的字母顺序排列。
10.
The Charater ofthe Round Eccentric Clamping and the Design Process of Round Eccentric;
圆偏心夹紧机构的特性与圆偏心轮的设计程序
11.
Immediately following this in time, order, or place;after this.
此后，今后时间、顺序或空间上紧接着地；这以后
12.
In the fullness of time, when the album was stuffed to overflowing, new pictures were placed between pages in strict chronological order.
最后，相簿插满了，新的照片就按年月顺序夹在页与页之间。
13.
Influence on the Structural Performance of Anchor Supporting System under Various Overload Orders and Soft Soil Interlayer
超载顺序和软土夹层对锚杆支护结构性能的影响
14.
steering gear column clamp
转向齿轮柱夹紧夹子
15.
clamp, work-holding, for machine tools
机床工件夹紧用夹具
16.
work-holding jig, for machine tools
工具机工件夹紧用夹具
17.
Place the shield disk (3) on the balance. Turn the disk counterclockwise until it stops and is secured.
将屏蔽或隔离环(3)装到天平上,左旋拧紧将如下各件按顺序安装
18.
Precedence, especially established by order of importance or urgency.
领先，优先尤指按重要性或紧急程度的顺序建立的优先地位