1.
The Micromagnetic Investigation of Exchange-spring and Exchange-bias Magnetic Multilayers
交换弹簧与交换偏置磁性多层膜的微磁学研究
2.
Replace spring tip inserts.
更换弹簧顶端插头。
3.
spring hanger bushing replacer
弹簧挂钩衬套换装器
4.
Torsional springs. Torsional springs that are loose and seem to have lost tension require replacement of the complete friction disk.
扭转弹簧:扭转弹簧松弛,似乎失去弹性,需更换整个摩擦盘。
5.
By increasing or removing spring and realizing scene conversion.
通过增加或去除弹簧实现现场转换。
6.
Never attempt to remove or alter these springs.
切勿尝试拆卸或更换这些弹簧。
7.
"Cushion springs. If the cushion springs under the facings appear to be cracked or weak, the friction disk should be replaced."
缓冲弹簧:如果衬片下的缓冲弹簧出现裂纹或磨损,摩擦盘也应更换.
8.
Camparing the treatment of PCoA aneurysms with HydroCoil embolic system and Guglielmi detachable coils
水凝胶弹簧圈与铂金微弹簧圈治疗后交通动脉瘤的比较研究
9.
Experimental Study on the Working Characteristics of Built-In Self-Rotating Spring Heat Exchanger;
内置自旋弹簧换热管工作特性实验研究
10.
"Overheated springs should be replaced, since they may have lost tension and will not operate satisfactorily. Spring pressure can be tested with a spring-tension tester."
过热的弹簧应该更换,因为失去弹性的弹簧运行时达不到满意的效果。可使用弹簧弹力计进行检测。
11.
The Apply of AC Servo-motor Technology in the Controlling System of Spring Sorting;
弹簧分选控制系统中交流伺服电机技术的应用
12.
If valves, springs, or seals are to be inspected/replaced at this time, refer to Valves and Valve Springs later in this section for proper procedures.
如果阀、弹簧或密封要在此时检查/更换，关于适当的程序，请参阅本节后面的阀及阀弹簧。
13.
spring bow (drawing instruments)
弹簧圆规（绘图仪）
14.
"Disconnect shifting linkages from transmission, hand-Brake linkage or spring, and speedometer cable."
从变速器上拆下换档装置、手制动装置或弹簧以及里程表传动软轴。
15.
Replace the spring ensuring that it seats properly on the disc holder.
更换弹簧以确保其能够正确的位于阀瓣固定器上。
16.
Study on the Working Characteristics of Built-In Rotatable Spring Heat Exchanger Tube and Analysis of the Flow Field of Miniature Hydraulic Turbine Inside Heat Exchanger Tube;
内置自旋弹簧换热管工作特性研究及管内液轮机流场分析
17.
Analysis of the breaker rejecting movement accident caused by a spring mechanism manual/electromotion changeover switch fault
一起弹簧机构手动/电动转换开关故障引起的断路器拒动事故分析
18.
resembling a spring or the action of a spring.
类似于弹簧或者弹簧的动作。