1.
Veneer peeling lathe of small dimension wood simple non-chuck spindle veneer lathe
小径材的理想旋切设备—简易无卡轴旋切机
2.
Hydraulic System Design and Research of Log-core Veneer Lathe
无卡轴旋切机液压系统的设计与研究
3.
Research on Log-Core Veneer Lathe Auto Control System;
原木无卡轴旋切机自动控制系统的研究
4.
Concurrent Engineering and Its Key Technology Analysis Application of Concurrent Engineering in the Development of Log-core Veneer Lathe
并行工程在无卡轴旋切机研制中的应用
5.
hydraulic double-chuck spindle veneer lathe
液压双卡轴木旋切机
6.
A plane section of a surface of revolution containing the axis of revolution.
切平面通过旋转轴回转面的部分平面
7.
Analysis of Rationality to the Seal Device Structure of the Rotate Axis Without Moving Leaking Point
旋转轴无动泄漏点的密封装置结构合理性分析
8.
Study on Dynamics of Vehicle with Independently Rotating Wheel of Non-Common Axle;
无公用轴独立旋转车轮车辆动力学研究
9.
Experiment Study on Spinning Trail of Pipe in Integral Mandrel-less Roller
整体无心轴托辊管体旋压道次的试验研究
10.
Stability and control analysis of rotor/ducted-fan based unmanned helicopter
旋翼/涵道风扇共轴式无人直升机操稳特性研究
11.
Revolving inertia vibration suppression model of bearingless synchronous motors
无轴承同步电机旋转惯性振动抑制模型
12.
the stationary part of a machine or power tool that supports and drives a revolving part (as a chuck or the spindle on a lathe).
机器或电动工具的支持或驱动旋转件（如卡盘或心轴）的固定部分。
13.
Monte Carlo Simulation of Vortex Phase with Disorder
蒙特卡罗方法模拟无序涡旋系统中的相图
14.
conveyer screw shaft coupling
输送机螺旋轴联轴节
15.
The Design of NC Revolving Platform and Dividing Control Card Used in Five-axis WEDM for Diamond Milling Cutters;
金刚石铣刀五轴线切割数控回转台及分度控制卡的设计
16.
Shaping Techniques for a Cassegrain System with Switching Feeds by Rotating the Subreflector
旋转副反射面切换工作馈源的卡塞格仑型天线赋形技术
17.
DANGER DO NOT OPEN UNTIL THE POWER SUPPLY HAS BEEN LOCKBD OFF AND THE SHAFT HAS STOPPED ROTATING. FAILURE TO DO THIS CAN RESULT IN SERIOUS BOOLY INJURY.
危险切勿在电源未切断，轮轴仍在旋转状态下开启，以免造成严重伤损。
18.
It adopts rotating hook driving axes as repairing structure which can ensure zigzag stitch evenly and without any fault.
采用旋梭驱动轴补偿机构，可确保无故障与均匀一致的人字车缝。