1.
Study on the Mechanism of Ultrasonic Vibration Aided Electrical Discharge Machining in Gas and Its Simulation;
超声振动辅助气中放电加工机理及仿真研究
2.
Study on the New Technology and Mechanism of Ultrasonic Vibration Aided Electrical Discharge Machining in Gas;
超声振动辅助气中放电加工技术及其机理研究
3.
Numerical Simulation of the Dielectric Medium in Submersed Gas-jetting EDM
液中喷气电火花加工的放电介质仿真分析
4.
Study on Removing NO_x from Flue Gas by Adding Ammonia and Propylene in Pulsed Discharge;
脉冲电晕放电烟气脱硝中NH_3、C_3H_6添加作用研究
5.
Experimental Study and Mechanism Analysis of Submersed Gas-Jetting EDM;
液中喷气电火花加工试验及机理研究
6.
Fundamental Study on WEDM in Gas;
气中电火花线切割加工的基础性研究
7.
Study on volt-ampere properties in WEDM
电火花线切割加工中放电间隙伏安特性的研究
8.
Real-time Detection Method of Discharge Gap in WEDM Processing
电火花线切割加工中放电间隙状态的实时检测
9.
Application of Wavelet and Fractal Theory in Spark Discharge Research
小波与分形论在电火花加工放电研究中的应用
10.
gas-discharge duplexer
气体放电天线双工器
11.
A premium quality, medium viscosity universal spark erosion fluid, specially developed for use in electrical Discharge Machine.
优质、中等粘度通用火花电蚀加工油，特别适用于放电加工。
12.
The Research of Open Practice Teaching Pattern of Electrical Engineering Practical Training Center
电气工程实训中心开放式实践教学模式的研究
13.
Investigation and Simulation of Ultrasonic Vibration Assisted Electrical Discharge Milling in Gas;
基于气体介质的超声振动辅助放电铣削加工技术仿真研究
14.
Study on the Mechanism and Finite Elements Simulation on Single Pulse Discharge on Gas Dielectric
气体介质单脉冲火花放电加工机理及有限元仿真研究
15.
Influence rule of discharging and controlling parameters on discharging states in EDM and modelling
电火花加工中电参数对放电状态影响规律及其建模
16.
Study on the Discharge Mechanism and Technology in Powder-mixed EDM;
混粉电火花加工放电机理及工艺研究
17.
Research on Micro-EDM Deposition Technique and Experiments in Gas;
气中微细电火花沉积加工技术及其试验研究
18.
Study on Mechanism of Low-Speed Wire Electrical Discharge Finishing in Gas;
低速走丝气中电火花线切割精加工机理研究