1.
Study on the Effect of Vertical Roller Cone Angle on the Flange Lateral Spread in H-Beam Rolling Process;
H型钢轧制过程中立辊锥角对翼缘宽展影响的研究
2.
Study of Effective Flange Width for Steel-concrete Composite Beam;
钢—混凝土组合梁有效翼缘宽度研究
3.
Concept and application of continuous box beam flange effective width
连续箱梁翼缘有效宽度的概念及应用
4.
The Top Flange Effective Width of Steel Box-girder Bridge;
钢结构人行天桥箱梁上翼缘有效宽度分析
5.
Effective Width and Plate-to-Plate Restriction Calculations of Profiled Steel Sheeting
压型钢板翼缘有效宽度及板组约束的研究
6.
Influences and treatment of the diaphragm structure on flange stress when box beam widening
箱梁拼宽时隔板构造对翼缘应力的影响及处理
7.
THE EFFECTIVE FLANGE WIDTH OF BEAM SUPPORT SECTIONS IN CAST-IN-SITU FLOORS UNDER VERTICAL LOADS
竖向荷载下现浇楼盖中的梁支座截面有效翼缘宽度
8.
Experimental Research and Analysis of Effective Flange Width of Beam End Section in Cast-in-Situ Concrete Frames
现浇混凝土框架梁端截面有效翼缘宽度的试验研究与分析
9.
According to the relationship between the structural strength and slenderness of plate elements, the limited width-to-thickness ratio of the flange of a box-section column under seismic load is derived.
由构件承载力与壁板宽厚比的关系,得出了抗震设计箱形截面柱翼缘板宽厚比限值。
10.
The outer rear edge of the wing of a bird, containing the primary feathers.
翼尖，前翼鸟翼的外后缘，包括初生毛
11.
The crack surfaces in the web and flange were subjected to visual examination in order to evaluate crack growth regions.
为了估计各裂纹扩展区，对翼缘和腹板的裂纹表面进行了宏观检验。
12.
leading-edge flap position indicator
前缘襟翼位置指示器
13.
trailing-edge flap position indicator
后缘襟翼位置指示器
14.
The ailerons are movable sections along the rear edges of the wings.
副翼是机翼后缘的可动部分。
15.
a straight line connecting the leading and trailing edges of an airfoil.
连接机翼的前缘与后缘的直线.
16.
The Relation of Closing up and Separating between the New Feeling Writer and the Left Wing Literary Arena;
新感觉派作家与左翼文坛的缘起缘落
17.
A seagull hit the right wing tip, leading edge flap sustained minor damage.
右翼尖与一只海鸥相撞，前缘襟翼受到轻微损伤。
18.
Since the wingspan of the twin-engine bombers was too wide for the ship’s elevators, they couldn’t be stored below.
由于这种双引擎轰炸机翼展超过了升降机的宽度，所以不能把它们放在甲板下的机库内。