1.
Quality Optimization of Cylinder Bore Surfaces for TJ376Q Gasoline Engines;
TJ376Q汽油机气缸体缸孔加工质量优化
2.
Engine Cylinder Block Crankcase
发动机气缸体曲轴箱
3.
Like the cylinder block, the head is made from either cast iron or aluminum alloy.
像气缸体一样，气缸盖是由铸铁或者铝合金制成。
4.
The cylinder head is attached to the block with high-tensile steel studs.
气缸盖与气缸体用高强度的钢螺栓缚连结。
5.
"In the other kind of valve mechanism for an engine, the valves are located in the cylinder Block instead of the head."
另一种气门机构的气门是装在气缸体上,而不是装在气缸盖上。
6.
"The Block and head can not be machined flat and smooth enough to provide an adequate seal. Thus, gaskets are used."
机器加工并不能使气缸体和气缸盖平整光滑到严丝密缝,这样就要使用气缸垫。
7.
The cylinder head fastens to the top of the block, just as a roof fits over a house.
气缸盖固定在气缸体的顶上，正像屋顶套在一所房子上面一样。
8.
The crankcase is the lower part of the engine cylinder block.
曲轴箱是发动机气缸体较低的部分。
9.
Research on Material Improvement for Vehicular Air Compressor Cylinder Body;
车用空气压缩机气缸体材质的改进研究
10.
The joint between the block and the head must be gas-tight so that none of the burning mixture can escape.
气缸体和气缸盖之间的连接必须密封以便没有燃烧的混合气体泄漏。
11.
Solution to Failed Products,Shell Core Bore Core in Diesel Engine Block
柴油机气缸体壳芯钻芯废品问题的解决
12.
Study on Design of Cylinder Block for Low Emission Medium-duty and Heavy-duty Diesel Engine;
低排放中重型柴油机气缸体的设计研究
13.
WD615 Engine Cylinder Block Microstructure and Properties of
WD615柴油机气缸体显微组织和性能的研究
14.
compressor ,multicylinder, for air or other gases
多缸空气或其他气体压缩机
15.
a cremation chamber fueled by gas.
用气体作燃料的燃烧气缸。
16.
The temperature of the gas rises. In the issue it expands in the cylinder.
气体的温度升高，因而它在汽缸里膨胀。
17.
280/330 Single-Cylinder Diesel Valve Train Total Design and Simulation;
280/330单缸机配气机构总体设计及仿真
18.
Research on In-cylinder Flow of Diesel Engine with CATIA
基于CATIA的柴油机缸内气体流动研究