1.
Research on Primary Dendritic Spacing under Unidirectional Solidification of Al-Cu Alloys;
Al-Cu合金定向凝固一次枝晶间距的研究
2.
INFLUENCE OF WITHDRAWING RATE TRANSITION ON THE PRIMARY DENDRITE ARM SPACING AND MICROSEGREGATION OF DIRECTIONALLY SOLIDIFIED SINGLE CRYSTAL SUPERALLOY DD3
抽拉速率跃迁对定向凝固单晶高温合金DD3一次枝晶间距和微观偏析的影响
3.
RELATIONSHIP BETWEEN COOLING RATE AND SECONDARY DENDRITE ARM SPACING FOR STEEL No. 45
45号钢二次枝晶臂间距与冷却速度的关系
4.
Effect of secondary dendritic arm spacing on center carbon segregation of slab
连铸板坯二次枝晶臂间距对中心碳偏析的影响
5.
The Influences of SDAS on the Aging Kinetics of A357 Alloy
二次枝晶臂间距对A357合金时效动力学的影响
6.
INFLUENCE OF ANTIMONY ON SECONDARY DENDRITE ARM SPACING OF PRIMARY AUSTENITE OF HYPOEUTECTIC GREY IRON
锑对亚共晶灰铁初生奥氏体二次枝晶臂间距的影响
7.
A Numerical Model and Simulation of Cellular/Dendritic Array with Forced Convection;
强迫对流对胞、枝晶间距影响的数值模型与模拟
8.
Study on modeling of solute concentration distribution in secondary dendrite during solidification of molten steel
钢凝固过程中二次枝晶间溶质分布的模型研究
9.
The Effect of Permanent Mold on the Arm-Spacing and the Fatigue Fructographies of the Low Chromium V-Ti White Cast Iron;
金属型铸造对低Cr─V─Ti白口铸铁枝晶间距和断口形貌的影响
10.
The spacing between atomic planes in a nickel crystal is 2. 15×??.
一块镍晶体中各原子平面的间距为2．15×?∶住?/UK>
11.
It's been a long time since your last visit to Taiwan;
距你们上次造访台湾已有很长的一段时间了；
12.
per acre six-row-sowing a time,the adjustment of linewidth as well as the rate of damage can not pass 5%.
一次实现6行播种,行间距可调,破碎率在5%以下.
13.
Your taps are too far apart. Try to tap twice quickly in the same place.
两次点击之间的距离太远。请尝试在同一地方快速地点击两次。
14.
To send out branches or subordinate branchlike parts.
分枝生出枝杈或象枝杈一样的次级部分的
15.
Application of RHEED in the Calculation of Al_2O_3 Interplanar Distance
RHEED在计算Al_2O_3晶面间距中的应用
16.
One party would offer a cigarette to the other habitually, as if this would shorten their distance.
人们见面后习惯性地为对方递上一枝烟，好像这样就拉近了彼此之间的距离。
17.
A secondary woody stem or limb growing from the trunk or main stem of a tree or shrub or from another secondary limb.
分枝从树或灌木的主干或另一次级树枝上生长出来的次级树枝
18.
Minor unit must be less than or equal to major unit.
次要刻度线间距必须小于主要刻度线间距。