1.
Bench-type fume hood is the main type in CCIQ laboratory.
台式通风柜是CCIQ实验室主要的通风柜。
2.
The pipe of fume hood should upward through the roof. There should be water pipe and water sink in the fume hood.
通风柜，通风橱的管道要通到屋顶，通风橱内要有水管，水槽。
3.
Standard fume hood is of60 or72 inches width.
标准的通风柜一般60或者72英寸宽度。
4.
Baffles: Baffles providing controlled air vectors into and through the fume hood shall be constructed from the same material as the liner.
扰流板：扰流板应该和内衬材料一致，其引导通风柜气体排除柜外。
5.
Physical and chemical labs: Air-exhausting system used for ventilation cabinet and reagent cabinet which need local ventilation should be installed in the ceiling and exhaust to the outside wall.
理化实验室：用于通风柜、剂柜等局部排风要求的排风机组，设置在实验室吊顶内并通过外墙排出。
6.
Hood light fixture: Two lamp, rapid start type, and UL listed fluorescent light fixture with solid-state typed ballast installed on exterior of roof.
通风柜照明：两个荧光灯管，快速启动类型，UL标准。镇流器安装在通风柜外部。
7.
The laboratory exhaust system includes exhaust duct works, exhaust fan, laboratory fume hood exhaust, laboratory canopy hood and cabinets needed venting.
实验室排气系统包括排气管路、气风机、验室通风柜管道、验室排风罩和特殊存储柜的排气管道。
8.
The switches and power sockets for fume hoods shall be placed on the outside of the fume hood.
所有的开关和插座都需安装在通风柜外部。
9.
The fume hood shall be tested in manufacturer's facilities in conformance with international standards such as ASHRAE110 for containment performance.
通风柜要经过生产厂家的检验，满足ASHRAE110的剩余浓度标准。
10.
Fixtures exposed to hood interior( i. e. tap nozzle) shall be made of brass with chemically resistant black vinyl coating.
通风柜里面的配件（头喷嘴）黄铜构成，外面环氧树脂喷涂。
11.
The interior material inside Fume Hood should have authorization test certificate to ensure excellent chemical performance.
通风柜内衬材料需要有权威机关的证明，有良好的化学抗性。
12.
This section sets out the design, fabricate, supply, delivery, installation, test and commission of the laboratory fume hoods (fume cupboards).
这一部分介绍了通风柜的设计、构造、材质、安装、检验等内容。
13.
Fume hood shall be designed to minimize static pressure loss. Bell shaped exhaust collar configuration shall be provided.
通风柜的设计要减少静压损失。因此一般在排气口附件采用钟型设计。
14.
Work surfaces shall be constructed from1-1/4 inch thick epoxy resin dished a nominal one-half inch to contain spills.
通风柜工作台面为1-1/英寸厚度的环氧树脂台面，其中有1/英寸的内凹槽盛溅出溶液。
15.
Benches are equipped with either epoxy resin sink or polyolefin oval cupsinks while fume hoods are equipped with polyolefin cupsinks.
工作台配备环氧树脂水槽或聚稀烃类椭圆形杯槽。通风柜里也安装聚稀烃类椭圆形杯槽。
16.
There are upper or lower or upper and lower vents.
溶剂柜上部、部、下部有通风口。
17.
Commonly used specification for steel book cabinets and information cabinets
GB/T13668-1992钢制书柜、资料柜通用技术条件
18.
It's a lovely flat with a bright, ventilated living room, two bedrooms with a walk-in closet and a modern kitchen.
这是个很好的单位，有光这、通风的客厅、两间连大型衣柜的睡房，还有一个现代化的厨房。