1.
Defects and its Prevented Measures of As-extruded Magnesium Sheets
镁合金板材挤压缺陷的研究及预防措施
2.
Analysis of extrusion-defect of piston and numerical molding process optimization
活塞的挤压缺陷分析及工艺的数值优化
3.
Study on Common Defects in HSn70-1 Extrusion Process and Products
HSn70-1合金挤压工艺及其挤制品常见缺陷研究
4.
The Analysis of Defects on the Surface Lacunas and Air Bubble of Hfe62-1 Cylindrical Pressure Parts
四六铁黄铜筒形件热反挤压表面重皮与气泡缺陷的分析
5.
Analysis on Cause of Typical Defect of Aluminum Alloy Extruded Products and Corresponding Solutions
浅谈铝合金挤压制品典型缺陷产生的原因及解决办法
6.
Reasons and Solutions About Folding Defect in Extrusion Forming of Thrust Bearing
止推轴承座挤压成形过程中产生折叠缺陷的原因及解决方案
7.
a concavity in a surface produced by pressing.
由于挤压而形成的凹陷。
8.
Influence by Oil Casing Imperfections on Anti-Collapse Strength
石油套管几何缺陷对抗挤强度的影响
9.
Combined with the actual production, the article analyzes ten kinds of defects, and countermeasures are presents.
结合生产实际,分析了铝合金挤压型材的十种缺陷,并提出了相应的对策。
10.
Analysis of the Influence of Tectonic Comress Stress over Coal-mining-induced Subsidence;
挤压构造应力对采煤沉陷的影响分析
11.
Defective solenoid pack (UD pressure in 4th gear)
有缺陷的电磁组（ＵＤ压力在第四个齿轮）
12.
A Research on the Reliability Method of the Pressure Vessels and Piping Defect Analysis Based on CEGB R6
压力容器缺陷评定的可靠性方法研究
13.
Defect Analysis on 220 kV Transformer Oil-immersed Capacitor Bushing
220kV变压器油纸电容式套管缺陷分析
14.
Defect Control of Thermal Insulation Parts in Molding Process
某防隔热构件模压工艺中的缺陷控制
15.
Safety Assessment Method of Pressure Pipe with Volume Defects
含体积缺陷压力管道安全评定的方法
16.
Analysis and Treatment of Pile Foundation Defects on Static Pressure Pre-stressed High Concrete Pipe Pile
静压PHC管桩桩基缺陷分析与处理
17.
Failure Analysis on 66 kV Capacitive Voltage Transformer Fault
66kV电容式电压互感器缺陷分析
18.
Analysis and improvement of PT secondary circle’s defect
PT电压二次回路缺陷的分析和改造