1.
Numerical Study on Thermal-Elasto-Plastic and Creep Deformation of Aluminum Electrolytic Cell;
铝电解槽槽壳热弹塑性及蠕变有限元计算
2.
Design of Web-based Temperature Monitoring System for Aluminum Reduction Cells
基于Web的铝电解槽槽壳温度监测系统设计
3.
Research and Design of Online Temperature-Monitoring of Aluminium Cell Shell and Diagnosis of Cell Status System;
铝电解槽槽壳温度在线检测及槽况诊断系统的研究与设计
4.
A groove around the cylinder of a bullet.
弹壳槽线一圈环绕着子弹的圆柱状凹槽
5.
Performance and Application Research of Shell-and-tube Ice Storage Tank;
壳管式外融冰槽热工性能及应用研究
6.
The Numerical Model of Original Shell in Grooved-Mold;
沟槽内壁结晶器初生坯壳的数学模型
7.
Research and Application on the On-line Temperature Detection of Aluminum Cell Shell and the Cell Status Diagnosis Expert System;
铝电解槽糟壳温度在线检测与槽况诊断专家系统的研究与应用
8.
Mount the drives in the case.
将软驱或IDE装置放入机壳中相对应的空槽中。
9.
Position dome/reading lamp housing at headliner cavity.
将圆顶照明/阅读灯外壳定位于车顶蓬内衬槽中。
10.
Slide and tap in reservoir retainer clips until tab locks to housing.
滑动并敲击贮油槽扣件夹，直至凸耳锁紧外壳。
11.
Research on Fatigue Failure of Reverse Vaulted and Notched Thin Metallic Shell under Uniform Pressure;
均匀压力下反拱带槽金属薄壳的疲劳特性研究
12.
Research on the Destruction Mechanism to Preventing and Curing Technology in the Thin Shell Aqueduct of Armored Concrete
钢筋混凝土薄壳渡槽破坏机理与防治对策研究
13.
Processing of Radiator of Conical Mould of Picture Tube
探索彩色玻壳锥凸模模具散热槽电极的加工
14.
Impact Analysis of the Ring Slot around the Bearing Shell of Top Rollers on Cot Telescoping Process
上罗拉轴承外壳环形槽对套制胶辊的影响分析
15.
Trim or remove excess sealant film in the rear main cap oil pan gasket groovDO NOT remove the sealant inside the rear main cap slots.
修整或清除后主盖机油底壳垫圈凹槽中过多的密封剂薄膜。切勿清除在后主盖槽中的密封剂。
16.
But as I told you, the main tanks are outside the real hull.
可是正如我已经告诉你的，主要的水槽都在真正的艇壳外面。
17.
CHARACTERISTICS OF CARBONIFEROUS CRUSTAL MOVEMENTS IN NORTH XINJIANG WITH REFERENCE TO THE TIME OF GEOSYNCLINAL CLOSING
新疆北部石炭纪地壳运动特征兼论地槽区封闭时代
18.
The Experimental Research of Alveolar Bone Regenerated by Compound Material of Carboxymethyl Chitosan Tricalcium Phosphate;
羧甲基壳聚糖-钙盐复合物诱导齿槽骨再生的实验研究