1.
Install the lower bearing inserts into the main bearing caps.
安装下轴瓦到主轴承盖。
2.
Measurement of Dynamic Stresses and Temperatures of Main Bearing Walls and Caps on an Engine Block
发动机缸体主轴承座及主轴承盖的动态应力和温度测量
3.
3D Finite Element Analysis of Suspended Main Bearing Cap of Diesel Engine
柴油机悬挂式主轴承盖的三维有限元分析
4.
3D Finite Element Analysis of Stiffness and strength of Main Bearing Cap of Internal combustion Engine
内燃机主轴承盖强度和刚度的三维有限元分析
5.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
6.
Oil may be forced out through the timing cover and rear-main bearing oil seals.
机油会从正时齿轮盖和后主轴承油封处压出。
7.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
8.
end shield bearing
机油滤清器内盖头轴承
9.
The bottom bearing applies both labyrinth seal and frame seal, which have good performance of sealing. The main shaft is anticorrosive.
下轴承端盖密封采用双重密封，可确保密封效果，主轴采用防腐新技术，能保护主轴免受腐蚀。
10.
Plain Bearing Block Housings are made up of cap, base ,aluminum bronze bushing and installing bolts, which mainly bear radial load.
滑动轴承座由上盖、底座、剖分轴瓦（铝青铜），安装螺栓组成，主要承受径向载荷。
11.
The feed holes for the crankshaft main bearings.
曲轴主轴承进入口。
12.
Crankshaft and main bearings service
曲轴和主轴承的维修
13.
Analysis and solution of cramped shield to be detachable in sealing bearings
带卷边防尘盖轴承活盖问题解决办法
14.
The Model Analysis of the Ceramic Bearing Electric Spindle;
陶瓷轴承电主轴主轴的振动模态分析
15.
These are the same as those used for the main bearings.
这些轴承与那些被用作主要轴承的轴承相同。
16.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
17.
Modeling for Rotor System of AC Magnetic Bearing Electric Spindle;
交流磁轴承支承电主轴转子系统建模
18.
Undersize crankshaft main bearing journals.
尺寸小于标准的凸轮轴主轴承轴颈。