1.
Aseismic Capacity of Frame-Shear Wall Structures with Different Percentages of Overturning Moment Resisted by Frame
框架倾覆弯矩比例对框架—剪力墙结构抗震性能的影响
2.
COMPARATIVE STUDY ON BENDING STRENGTHENING METHOD OF NEGATIVE MOMENT AREA AT BEAM END IN RC FRAME
梁端负弯矩区受弯性能加固方法对比试验研究
3.
The actual stress is not proportional to the bending moment.
实际上应力与弯矩不成正比。
4.
Analysis on the moment transferring factor of RC out-of-plane beam-wall joint
钢筋混凝土梁-墙直交节点弯矩传递比例分析
5.
Analysis and Comparison of Displacement Impact Coefficient with Moment Impact Coefficient of Simple-supported Beam
简支梁位移冲击系数与弯矩冲击系数大小分析与比较
6.
Comparison of the Spline-based Method of Cubic Spline Function and the Similarities and Differences of Three-moment Method
三次样条函数的基样条法和三弯矩法之异同比较
7.
Pushover analysis on rectangular column frames with different column-to-beam strength ratios
RC矩形柱框架结构不同柱-梁抗弯强度比的Pushover分析
8.
The beams are designed with respect to the bending moment.
梁是按照弯矩设计的。
9.
On the influence of the bending moment waveform disturbance on the pure bending beam flexion
弯矩波形扰动对纯弯梁弯扭屈曲的影响
10.
The Calculatiou of critical load by torsion angle-bending moment matix;
用转角弯矩矩阵确定压杆的临界荷载
11.
The simplified calculation formula form of cracking moment is simple and the analytical results agree well with that of experiments.
经简化后的开裂弯矩计算公式形式比较简单,计算结果与试验结果基本吻合。
12.
The Influence of Cold-Formed Effect to Stress Capacity Performance of Cold-Formed Rectangular Hollow Section Beams;
冷弯效应对冷弯矩形钢管梁受力性能的影响
13.
Research on the Curves Versus Moment Hysteretic Behavior of Thin-walled Cold-formed Steel Beams
冷弯薄壁型钢梁的弯矩-曲率滞回性能试验研究
14.
Calculation for Cracking Moment of SRC Flexural Member
型钢混凝土受弯构件开裂弯矩的计算初探
15.
Study of plastic limit load of the combined fittings of double elbows under in-plane bending moment
面内弯矩下双弯头组合管件的极限载荷研究
16.
Bending moments produced by lift generally have only a small effect on the resultant bending moment.
一般由升力所产生的弯矩对最终的弯矩只有很小的影响。
17.
Torque and Bending Moment in a Shaft with Combined Deformation Measured by Resistance Strain Gauge Method
电阻应变计法测量组合变形轴的扭矩和弯矩
18.
ANALYSIS OF COMPOSITE BENDING MOMENT DIRGRAMS UNDER BENDING AND BENDING DEFORMATON FOR ROUND SHAFT;
关于圆轴含有弯弯组合的合成弯矩图形状的讨论