1.
cross-junction box
交叉接线盒，交叉接线箱
2.
Each byte is connected with an 8 pin terminal block.
各组均连接到一个8引脚接线盒上。
3.
junction box fitted with electrical connection for a voltage not exceeding 1000V
接线盒 ,配有电线接头的,越过1000V电压用的
4.
joint box compound
接线盒材料电缆套管填充剂
5.
Fuses in the junction block and the Power Distribution Center (PDC)
接线盒和动力分配中心（PDC）中的保险丝
6.
Unplug the combination flasher from the junction block.
从接线盒中拔出组合闪光器。
7.
an electrical connector socket designed for the insertion of a plug.
为插入插头而设计的接线盒插座。
8.
Means to Reduce the Electrical Terminal Box Size of Underground Explosion-proof Motors
减小井下防爆电机接线盒尺寸的措施
9.
The Formulation and Interpreting Standard of Patch and Connect Box for Sound Reinforcement System
《舞台扩声系统跳线柜、综合接线箱、地板接线盒设置规范》的制订
10.
Terminal block connections - easy and safe wiring connections are made possible by factory installed terminal blocks.
端子接线盒---这种在工厂就配置好的端子接线盒,使得电源连接更加方便,更加安全。
11.
Installation Kits/ Accessories include the necessary components to perform straight or tee splices, power connection boxes and water-resistant end seal terminations for final installation.
安装附件：安装附件/件包括伴热线安装时所用电源接线盒；两通、通及防水的尾端接线盒。
12.
Where there is distortion,crack or damage on the junction box,it must be stopped using.
发现接线盒外壳有变形、裂痕和损坏、应停止使用。
13.
Check if explosion proof junction boxes are damaged or missing.
④ 检查各防爆接线盒是否有损伤和残缺情况。
14.
Spare parts: Product should with switch board, wiring box and platoon a place with a draught.
零配件：产品应附有开关板、接线盒和排风口。
15.
Completely pre-wired - with pressure lug terminal block eliminating need for splicing or taping of wires.
全部预置线路--配置弹性接线片的终端接线盒,不需要再缠绕和捻接电源线。
16.
Approach on Explosion Protected Cable Sealing Joint for Flameproof Motor
隔爆型电动机接线盒防爆电缆密封接头引入装置问题探讨
17.
Ground the water heater by connecting a grounding wire from the electrical service ground terminal to the green grounding screw in the junction box of the water heater.
通过将电气部件上的接地端子连接到热水器接线盒里绿色接地螺丝上，实现热水器的接地。
18.
Loosen the screw holding the junction box cover to the top of the water heater. Set the cover aside.
卸下热水器顶部接线盒盖上的固定螺丝。把盖子放在旁边。