1.
Influence of Drill's Edge Preparation on Drilling of 42CrMo
钻头刃口处理对钻削加工42CrMo的影响
2.
A Study on the Leaned Burr Formation in Drilling process
钻削加工中进给方向毛刺生成机理的研究
3.
Study on the Drilling Technology of CFRP;
碳纤维复合材料(CFRP)钻削加工技术的研究
4.
The Investigation of Drilling Performance of Short Fibre-reinforced PEEK Composites;
短纤维增强PEEK复合材料钻削加工性能研究
5.
Usually the machine function, such as a drilling operation, is also activated at each point by command from the NC program.
通常,数控程序指令在每一个点位启动机器运转,如钻削加工。
6.
Determination Method of Drilling Parameters Applied for Machining Centers
应用于加工中心的钻削用量确定方法
7.
Digital Control Machining Techniques of Lip Mould and Diagonal Water-hole Drilling
唇模数控加工工艺设计与斜水孔的钻削
8.
Wear Characteristic of Twist Drills in Cutting Machinable Ceramics;
可加工陶瓷切削中钻头磨损特性的研究
9.
Kinematics Characteristics of Vibration Drilling and Its Influence on Processing Quality
振动钻削的运动学特性及其对加工质量的影响
10.
Applying of Ultrasonic Vibration Drilling on Micro and Small Hole Machining
振动钻削技术在深小微孔加工中的应用
11.
Analysis of Dynamic Thrust, Torque and Machining Accuracy for Step Multi-element Varying-Parameter Vibration Drilling
阶跃式多元变参数振动钻削的动态轴向力、扭矩及加工精度分析
12.
In view of cost, practicability and maneuverability, the special sintering diamond trepanning drill was developed for drilling ceramic composite components originally.
根据复合构件加工中的各种缺陷，分析了采用预压应力钻削对改善表面加工质量的重要性。
13.
These arise from machining, grinding, straightening, welding, casting, spinning, forging, and rolling operations, which will also furnish a marked contribution to the shape change.
经过加工、磨削、调直、焊接、铸造、钻孔、锻造和滚压等操作工序，对工件形状变动影响很大。
14.
Drilling and forming mechanisms of ground surfaces in engineering ceramics
工程陶瓷的磨削钻孔及表面形成机理
15.
The Analysis of the Drilling Technology of the Cylinder of the Hydraulic Breaker
液压破碎锤缸体钻削工艺的分析研究
16.
Development and Performance Test of Piezoelectric Vibrating Drilling Table
压电式振动钻削工作台及其性能测试
17.
This article is focused on the ultra-precision machine technology, and SPDT and ultra-precision grinding technologies.
因此，本文针对超精密加工设备，以及单点钻石车削与超精密轮磨技术分别介绍说明。
18.
Study on the Forming Principle of the Cutting Burr in Turning
车削加工中切削毛刺生成机理的研究