1.
Four undercompaction zones are divided on the undercompaction curves of shale in the Eogene system of De Nan depression.
德南洼陷下第三系泥岩欠压实曲线可划分四个欠压实带；
2.
The Analysis on the Performance of OFDM and the Realization of 10KV Brand Band Power Line Modem;
OFDM性能分析及中压宽带MODEM的实现
3.
Rate-Controllable Near-Lossless Image Compression and Its FPGA Implementation;
带码率控制的近无损图像压缩及其FPGA实现
4.
Realization and Design of a Band-Gap Reference Voltage Based on Low Dropout Voltage Regulator;
一种基于LDO带隙基准电压源的设计与实现
5.
Design and Study on Hydraulic Mass Flow Gauge Control System of the Cold Strip Rolling Mill;
冷带轧机秒流量液压厚控系统设计及实验研究
6.
A Practical Curvature-corrected Technique for Bipolar Bandgap Reference;
一种实用的带隙参考电压源曲率校正方法
7.
The Oil-Flow Electrification Testing System Design for Oil-Paper Insulation in Converter Transformer
换流变压器油纸绝缘油流带电实验系统设计
8.
Experimental investigation of flow field in both straight and positive bowed stator passages with cantilever blades
带根部间隙的直、弯压气机静叶流场的实验
9.
Backward analysis for isentropic compression experiments with windows backed on samples
带窗口准等熵压缩实验的流场反演技术
10.
Study on the formation of shear bands in BMGs by "in-situ" compression tests
大块金属玻璃剪切带形成的“原位”压缩实验研究
11.
Study on the Mathematical Model and the Experiment for Static Electrification Owing to Oil Flow in EHV Power Transformers
超高压变压器油流静电带电的计算模型及实验研究
12.
Experimental and Numerical Investigation on Stall Flow Phenomenon in the Centrifugal Compressor with Vaneless Diffuser;
带无叶扩压器的离心压缩机失速现象的实验和数值研究
13.
A region of low barometric pressure.
低压带气压低的地区
14.
self-contained press
带有液压泵的压制机
15.
Biomechanical study of reconstruction of ACL by hamstring tendons knot implant fixation
肌腱结嵌压固定法重建前交叉韧带生物力学实验研究
16.
Biomechanical Experimental Research on the Compression Plate of Gear Contact Plate-band and Channel Type for Femoral Fractures;
齿接触板-带式槽形加压钢板固定股骨骨折的生物力学实验研究
17.
Experimental Study and Numerical Simulation of the Flat Ribbon Wound Pressure Vessels Subjected to Internal Blast Loading;
爆炸载荷作用下扁平绕带高压容器实验研究和数值模拟
18.
The Technology Analysis and Experimental Research on Round Extrusion Part with Intra-cavity Rib Forming of Aluminum Alloy;
铝合金内腔带筋筒形挤压件成形工艺分析与实验研究