1.
Microstructural Homogeneity in Hypereutectic High Cr Cast Iron by Semi-solid Rheo-extrusion
半固态流变挤压过共晶高铬铸铁组织均匀性分析
2.
Theoretical Analysis on Squeeze Flow of Electrorheological Fluid between Two Parallel Disks;
电流变液平行圆盘挤压流的理论分析
3.
Extrusion force of HHE can be minimized and the disfigurement of extrusion products can be avoided when the viscosity of the medium is proper.
挤压介质的粘度是关系到坯料变形流动的润滑性能及挤压变形流动性能的关键。
4.
Study on the Materials Flowing and Deformation Behavior by Equal Channel Angular Pressing(ECAP)
等径角挤压过程中材料的流变行为研究
5.
Mechanical behavior of magnetorheological fluid under compression mode
基于挤压模式下磁流变液力学行为的实验研究
6.
extrusion stress
(塑性变形的)挤压应力
7.
Characteristics of Magneto-rheological Damper with Squeeze Mode and Its Effect on Helicopter "Ground Resounance" Dynamic Stability;
挤压式磁流变减摆器特性及其对直升机“地面共振”的影响研究
8.
Analysis of squeeze flow of bi-viscosity fluid between two rigid spheres
两刚性圆球间双黏度流体挤压流动压力分析
9.
Numerical Simulation of Metallic Flow Forming via Extrusion in Pocket and Porthole Dies
导流模和分流模金属挤压流动成形的数值模拟
10.
dead metal zone
死(金属)区(挤压时模角处金属不能流动)
11.
When you close your hand and press, some of the water gets out.
当你把手握紧挤压时，会流出一些水。
12.
Research on CAD/CAE System for Porthole Extrusion Moulds of Hollow Aluminum Profiles;
空心铝型材分流组合挤压CAD/CAE研究
13.
THE HYDRODYNAMIC LUBRICATION RESEARCH ON THE PROCESS OF HYDROSTATIC EXTRUSION;
静液挤压过程中的流体动力润滑研究
14.
Study on Fluidity of ZL101 in Semi-solid Micro-Extrusion
ZL101铝合金半固态微挤压流动性研究
15.
Texture Evolution of AZ31 Magnesium Alloy under the Different Extrusion Ratio and Extrusion Temperature
AZ31镁合金在不同挤压比和挤压温度下的织构演变
16.
If you press this ball hard, it will change its shape.
如果你用力挤压这个球，它就会变形。
17.
bend or crush(sth)so as to spoil its natural shape
扭曲或挤压（某物）使之变形
18.
Study on Mechanical Behavior of AZ91 Magnesium Alloy Subjected to Hot Extrusion;
挤压变形AZ91镁合金的力学行为研究