1.
Bottom water coning is an important factor affecting reservoir development effect, causing earlier water breakthrough, rapid water cut increase and production decrease.
底水锥进是影响底水油藏开发效果的重要因素。
2.
The Study of Prediction of Water Coning and Decision-making Technique for Water Shutoff for Bottom-water Reservoir;
底水锥进预测及底水治理决策技术研究
3.
Study on Influencing Factors Caused by Bottom Water Coning in Sandstone Gas Reservoir with Bottom-water
底水锥进对砂岩底水气藏开发效果的影响
4.
An Approach to Prevent Reservoirs from Bottom Water Coning and Its Applicability
一种抑制底水油藏底水锥进的方法及可行性
5.
NEW-TYPE HORIZONTAL WELL COMPLETION METHOD OF DELAYING AND CONTROLLING BOTTOM WATER CONING
延缓和控制底水锥进的水平井完井新方法
6.
Improvement of Precision Forging Process for a Outer Cone Gear Ring in Double Cone Synchronizer
双锥同步器外锥环精密锻造工艺的改进
7.
Analysis and design of a novel omni-directional broadband biconical antenna for mobile communication
一种改进型全向宽带双锥天线的研究
8.
Improved Design of LXA Double-tapered Rotary Vacuum Drier
LXA双锥真空回转干燥器的改进设计
9.
This is important for effective prevention and treatment. This paper reviews and summarizes some methods currently used in the diagnosis of keratoconus.
及早发现圆锥角膜 ,是进行有效防治的基础 ,现就目前圆锥角膜的诊断方法进行了简要论述。
10.
Using multiple side cone into a pulp and stainless steel pressure trough net-net-cage.
采用方锥多管进浆，压力网槽不锈钢片式网笼。
11.
Improve Design About Clear Storehouse Applicance Four Arris Awl Tpey Bottom Catch Coal Storehouse in Jiexiu Coal Washing Plant
介休洗煤厂受煤坑四棱锥底清仓器的改进设计
12.
Occlusal Reconstruction with Konuskronen Telescopic Dentures;
应用圆锥型套筒冠义齿进行咬合重建修复
13.
Numerical Simulation of Axisymmetric Inlets Square Separator;
带内锥的轴对称进口方形分离器的数值研究
14.
Improved Scanning and Approximate Reconstruction Algorithm of Cone-Beam Industrial CT;
锥束工业CT扫描方式与近似重建算法的改进
15.
Imporvment on the Pulling Processs and the Polarization Dependent Loss of 1X2 Fiber FBT Couplers
1X2单模融拉型光纤耦合器拉锥工艺与PDL的改进
16.
Crash failure analysis of intake valve seat
某型柴油机进气门盘部、锥面掉块失效分析
17.
Numerical Simulation of the Flow Field in Double Cone-Diversion Gas Distributor
双锥导流式进气分布器内流场的数值模拟
18.
Improving discussion of inspecting method for tapered roller bearing inner ring camber
圆锥滚子轴承内圈凸度检测方法的改进探讨