1.
It's mainly used in ladle backing layer and tundish backing layer.
自流浇注料还可采用机械化施工。
2.
Relationship between rheological properties and flowability of corundum based self-flow castables
刚玉质自流浇注料流变性和流动性的关系
3.
It is called“ The Fourth Generation Castable”.
莫来石质自流浇注料适用于钢包永久衬和中间包永久衬。
4.
Rheological property of bauxite based Al_2O_3-MgO vibration castable
矾土基Al_2O_3-MgO质振动浇注料的流变性能
5.
Design of auto-stripping injection mould with parting-out in sequence and pin gate mechanism
顺序分型点浇口自动脱料注射模设计
6.
Rheological Study of Sol-Gel Bonded High Alumina Castables
溶胶-凝胶结合高铝质耐火浇注料的流变学研究
7.
Effect of Dispersants on the Rheological Behavior of the Matrix Slurry of Corundum Based Castables
分散剂对刚玉质浇注料基质流变行为的影响
8.
The flow rate, beams result shows the amount and rate of polymer that is delivered through runners into the mold cavity, allowing you to optimize the runner system design.
柱体元素流动率?示柱体元素内塑料的流动率，主要是浇注系统，为优化浇注系统提供依据。
9.
The Study of Flow Behavior of Plastic Melt in the Gating System of Injection Mold
塑料熔体在注射模具浇注系统中的流动行为研究
10.
Preparation of High-Performance Corundum Castable Refractory Used for FBC Boilers
循环流化床锅炉用高性能刚玉质耐火浇注料的研制
11.
Study on Effect of Dispersants on Rheological Behavior of the Matrix Slurry of Corundum Based Castables
分散剂对刚玉质浇注料基质浆体流变性能的影响
12.
Design of Auto-Sheared Injection Mold for Edge Gate of FPD Cabinets
自动切除平板电视面框侧浇口废料的注射模设计
13.
Design of Injection Mold Gating System of the Plastic Gear Based on MoldFlow Software
基于MoldFlow塑料齿轮注射模浇注系统设计
14.
The practice of on-the-spot casting of the iron runner at No. 10 BF of Anshan Iron & Steel Group Co.
鞍钢10号高炉现场浇注铁沟料实践
15.
Study on Casting Material for Blast Furnace's Trough Made of Al_2O_3-SiC-C;
Al_2O_3-SiC-C质高炉出铁沟浇注料的研究
16.
Research on Properties of MgO-Al_2O_3 Based Castable for Ladle Slag Line;
钢包渣线用镁铝质浇注料的性能研究
17.
Study on Properties of Alumino-silicate Castables for Burnt Stove Door;
焦炉炉门用铝硅系浇注料的性能研究
18.
Effects of Binders on Properties of Alumina Magnesia Based Castable
不同结合系统铝镁浇注料的性能研究