1.
Thermal balance and finite element analysis of temperature field for hot runner plate
热流道板的热平衡及温度场的有限元分析
2.
Their preform moulds could be 2-cavity based and use a hot plate or hot runner design.
模具有用两腔的，采用热板/热流道设计。
3.
The Experiment Study of Heat Transfer Enhancement and Flow Resistance about Hole s Baffle;
设置开孔折流板通道内的换热及流动特性研究
4.
Heat transfer and flow resistance in back and forth flow path of plate-fin
板翅往复流道间的传热与流阻性能研究
5.
Heat transfer in rectangular pin-finned channel with perforated plate
带射流孔板矩形扰流柱通道内的壁面换热
6.
An analysis for flow and heat transfer between two parallel plates microchannel with one wall heated in slip flow regime
滑移流区平行平板微通道内单侧加热流动与换热
7.
Multi-cavity preform moulds do not use the cold runner design. An often-used design for the runners is hot plate design.
多腔的瓶坯模具都不采用冷流道的。较简单的流道是热板设计。
8.
Design of Injection Mould with Wedge-shaped Plate Typing and Hot Runner System for Mineral Water Bottle Parison
楔形导板分型矿泉水瓶坯热流道注塑模设计
9.
THE NUMERICAL SIMULATION OF FLOW AND HEAT TRANSFER IN ROUGH FLAT MICRO-CHANNELS
粗糙平板微通道流动和传热的数值模拟
10.
Analysis of Air Channel Blockage in the High-pressure Plate-fin Heat Exchanger for Internal-compression Air Separation Unit
内压缩流程空分设备高压板翅式换热器空气通道堵塞的分析
11.
Experimental Research on Boiling Heat Transfer Characteristics of Nanofluids in Miniture Flat Heat Pipe Evaporator with Micro-Grooved Surface;
小型重力型微槽道平板热管蒸发器内纳米流体沸腾换热特性的实验研究
12.
heating by means of wall or floor or baseboard or ceiling panels containing electric conductors or heating pipes.
通过含有电力供热体或加热管道的墙壁、地板、护壁板或天花板供热。
13.
Performance Evaluation of Total Entropy Increase Flower Baffle Heat Exchanger and Single Segmental Baffle Heat Exchanger
花板换热器及折流板换热器总熵增率性能评价
14.
FLOW AND HEAT TRANSFER CHARACTERISTICS OF FLAT PULSATING HEAT PIPE
平板脉动热管的流动和传热特性研究
15.
Microfluidic Flow and Heat Transfer in Microchannel Heat Sinks;
微管道换热器内微流体的流动与换热
16.
CALCULATION OF HEAT TRANSFER AND FLOW RESISTANCE OF SPIRAL PLATE HEAT EXCHANGERFOR GAS-LIQUID
螺旋板式换热器气－液换热时流阻及传热计算
17.
Numerical Analysis of the Heat Transfer Character of Cold Plate of Two-phase with High Heat Flux;
高热流密度相变均热板传热特性的理论研究
18.
Regulation Mode of Variable Flow Heat-supply System in Substation Using Plate Heat Exchangers
板式换热器热力站变流量供热系统调节方式