1.
EFFECT OF SURFACE PRE-TREATMENTS ON DURABILITY OF EPOXY BONDED JOINTS WITH EPOXY GLUE FOR PLATES OF Al AND Ti
不同表面处理方法对环氧胶接接头老化性能的影响
2.
a Buna-N cable grommet or a strain relief fitting shall be provided in addition to the epoxy sealed leads.
除此之外,还应该配置丁纳橡胶-N电缆索环或应变消除接头,进一步强化环氧树脂密封接头。
3.
Optimization on Stress Distribution of Adhesive Single Lap Steel Joint;
钢/环氧单搭接接头应力分布的优化
4.
The Study on Epoxy Adhesive Used in the Heat Exchanger
换热器粘接用环氧树脂胶粘剂的研究
5.
Ultrasoinc Nondestructive Characterization of Strength and Environmental Degradation of Adhesive Joints;
胶接接头强度及环境退化的超声波无损定征
6.
Influence of modified epoxy adhesive on adhesion of stainless steel and casting polyurethane rubber
改性环氧底胶对不锈钢与聚氨酯橡胶粘接的影响
7.
The Effects on Aluminium Alloy Welded Joint Properties of Space Thermal Cycling and Atomic Oxygen
空间热循环及原子氧对铝合金焊接接头性能的影响
8.
STRESS AND STIFFNESS ANALYSIS OF BI-ADHESIVE BONDED SINGLE-LAP JOINTS
混元胶接单搭接头的应力与刚度分析
9.
Effect of curing procedure on the impact toughness of adhesively bonded joints
固化工艺对胶接接头冲击性能的影响
10.
Effect of Recessed Bonding on Stress Distribution and Strength of Adhesively Bonded Joints
间隙连接对胶接接头应力分布和强度的影响
11.
Elastic Stress Analysis of Single-Lap Adhesive-Bonded Joints
单搭接胶接接头弹性应力的二维分析方法
12.
Influences of adherent thickness,temperature and velocity on strength of adhesively-bonded single-lap joints
板厚、温度和速度对单搭接胶接接头强度的影响
13.
Study on influencing factors of epoxy resin bond strength used in superhard grinding wheels
超硬磨具用环氧树脂胶粘剂粘接强度影响因素的研究
14.
Influence of surface grafting nano-calcium carbonate modified epoxy adhesive
纳米碳酸钙表面接枝改性对环氧胶粘剂性能的影响
15.
Influences of polyurethane structure on bonding performance of epoxy resin adhesive modified by polyurethane
聚氨酯结构对聚氨酯改性环氧树脂胶粘剂粘接性能的影响
16.
Study on influence of adhesive layer size on performance for single-lap bonding joint
胶层尺寸对单搭胶接接头性能的影响研究
17.
Study on influence of part flaw of adhesive layer on load capacity of adhesive joints
胶层局部缺陷对胶接接头承载能力的影响研究
18.
all conductor leads shall terminate at a terminal board that is permanently cast into the epoxy-sealed cable entry area.
所有导体接头都应该连接在接线端子板上,并采用环氧树脂永久密封在电缆进入区。