1.
The research and application of contact trace of crossed helical gear pair
交错轴斜齿轮副接触迹的研究与应用
2.
Calculation Method of Sliding Ratio for Spot Contact Tooth Surfaces and Application to Crossed Helical Involute Gears
点接触齿面滑动率计算方法及其对交错轴渐开线斜齿轮传动的应用
3.
Improper adjustment of differential bearings.
差速器轴承调整错误。
4.
Syntax error in axis definition, near: '%1'
轴定义中的语法错误，靠近:“%1”
5.
The effect of G_x and G_y on Coriolis illusion
不同轴向的径向加速度对科里奥利错觉的影响
6.
Research on Hydrodynamic Characteristics of Six-leaf Dislocated Floating-ring Bearing
六叶错位浮环轴承流体动力学特性的研究
7.
The Triaxial Magnetic Flux Leakage Signal Analysis of Spiral Weld Roof Topping and Hi-Low Defects
螺旋焊缝噘嘴错边缺陷三轴漏磁信号分析
8.
Allowing one axis of the ellipse to dwindle to zero, the crack limit solution is obtained.
将椭圆一轴缩小到零,得到了裂纹情况的位错象力。
9.
The same machine was used by Pomeroy (1970) to explore the effect of skew.
Pomeroy（1970）利用同样装置对轴线交错的影响进行了探索。
10.
Screw hollow and motor spindle are distributed staggered and equally.
螺纹安装孔的位置与电装电机轴线成错开对称分布。
11.
The Infection and Control Produced by the Dislocation of the Measuring Jaw for Internal Diameter and the Axis Width in the Measurement
卡尺内量爪错位和轴线宽度对测量的影响和控制
12.
Influence of Rotor Axial Shifting on Dynamic Characteristics in Staggered Labyrinth Gland
转子轴向偏移对交错齿迷宫密封动力特性的影响
13.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
14.
Axis Panzerfaust ability no longer has a50% chance to miss moving heavy vehicles.
轴心国国民掷弹兵的铁拳火箭筒现在对移动中的车辆会有50%错失几率。
15.
maneuvering shaft
分配轴控制轴倒转轴
16.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
17.
crankshaft (main journal turning lathe)
曲轴（主轴颈）车床
18.
camshaft(journal )turning lathe
凸轮轴（轴颈）车床