1.
Thermal balance and finite element analysis of temperature field for hot runner plate
热流道板的热平衡及温度场的有限元分析
2.
Numerical Simulation on Flow-Structure Interaction for Flexible Plate in Narrow Flow Channel
窄流道中柔性单板流固耦合数值模拟
3.
Their preform moulds could be 2-cavity based and use a hot plate or hot runner design.
模具有用两腔的，采用热板/热流道设计。
4.
Study on the Fluid Flow Plate with Humidify Channel for PEMFC;
PEMFC带增湿槽道集流板的研究
5.
The Experiment Study of Heat Transfer Enhancement and Flow Resistance about Hole s Baffle;
设置开孔折流板通道内的换热及流动特性研究
6.
Characteristics Research of the Spillway Discharge on Overflow Concrete Face Rockfill Dam;
溢流式面板堆石坝坝体溢洪道泄流特性研究
7.
Heat transfer and flow resistance in back and forth flow path of plate-fin
板翅往复流道间的传热与流阻性能研究
8.
Heat transfer in rectangular pin-finned channel with perforated plate
带射流孔板矩形扰流柱通道内的壁面换热
9.
Multi-cavity preform moulds do not use the cold runner design. An often-used design for the runners is hot plate design.
多腔的瓶坯模具都不采用冷流道的。较简单的流道是热板设计。
10.
'See!' cried madame, pointing with her knife. 'See the old villain bound with ropes.
“看呀：”老板娘用刀指着叫道，“看那老流氓捆在那几。
11.
Design of Injection Mould with Wedge-shaped Plate Typing and Hot Runner System for Mineral Water Bottle Parison
楔形导板分型矿泉水瓶坯热流道注塑模设计
12.
THE NUMERICAL SIMULATION OF FLOW AND HEAT TRANSFER IN ROUGH FLAT MICRO-CHANNELS
粗糙平板微通道流动和传热的数值模拟
13.
Effect of different clapboards structure in turbine blade trailing edge complex passages on flow characteristics
涡轮叶片尾缘复合通道隔板结构对流动的影响
14.
Fabrication of Nanostructure by Template Method in Microfluidic Systems
模板法合成纳米通道在微流控系统中的应用
15.
Calculation Methods for Flow-Induced Vibration Response in Pipes with Orifices
孔板诱发管道流致振动响应的计算方法
16.
however,the difference decrease to 2.6% when the inflow Mach number increases to Ma 8.
而当来流马赫数为8.09时,侧板前掠的进气道流量系数仅高2.6%。
17.
An analysis for flow and heat transfer between two parallel plates microchannel with one wall heated in slip flow regime
滑移流区平行平板微通道内单侧加热流动与换热
18.
Research and Analysis of Pump House Ledger Wall of the Vertical Axial Flow Pumping Station with Elbow Type Inlet Passage by FEM;
立式轴流泵站肘形进水流道泵房底板有限元分析研究