1.
Excessive friction in strut upper bearing
支柱上轴承磨损过度
2.
upper center crankshaft bearing
曲轴主轴承上中轴瓦
3.
Remove the lower insert from the bearing cap.
从轴承盖上拆去下轴瓦。
4.
The journal rubs against the bearing surface.
轴颈在轴承面上摩擦。
5.
Remove thrust bearings from rear main bearing carrier.
从后主轴承托架上拆下止推轴承。
6.
Pilot bearing in crankshaft. The pilot bearing in the crankshaft is usually either a Bushing or a Ball bearing.
曲轴上的导向轴承:曲轴上的导向轴承一般或者是轴瓦,或者是球轴承。
7.
governor upper bush
调速器上部轴承衬套
8.
radial bearing upper drive sub
上部径向轴承传动接头
9.
The carriage is supported on guide shafts.
托架支承在导轴上。
10.
Shaft Assembly (Male, female, washer, grease….
轴组件（轴，轴套，轴承，油脂。。。）
11.
RUGGEDNESS. Automotive ring gear differential. Axle shafts on roller bearings.
强度：自动差速齿轮，滚子轴承上的刚性车轴。
12.
Application of Oil Gas Lubrication Technique to Bearing of High-Speed Motorized Spindle
油气润滑技术在高速电主轴轴承上的应用
13.
Bearing Clearance (#1 Journal)
轴承间隙（#1轴颈）
14.
"If the bearings seem to have worn fairly uniformly, then the chances are that only crankshaft-journal checks and bearing replacement will be required."
如果轴承看上去似乎已磨损的相当均匀,那么只需要检查曲轴轴颈并更换轴承。
15.
This bearing limit rotational speed is low, (therefore mainly applies on the mill calls rolling mill bearing).
该轴承极限转速较低，主要应用于轧钢机上（故称轧机轴承）。
16.
The trunnion assembly is supported by air bearings at the end of each arm and is held in position by brake shoes at each bearings.
耳轴组件的支承是每根臂末端的空气轴承，轴承上的闸瓦起定位作用。
17.
All bearings are on immovable supports at the same elevation.
全部轴承都位于同样高度不可动的支承上。
18.
plain bearing housing with bearings
装有轴承的普通轴承座