1.
Calculation of actual contact angle during elastic contact deformation between recirculating ball screw and nuts
滚珠丝杠副产生弹性接触变形时实际接触角的计算
2.
THE EFFECTS OF CONTACT DEFORMATION OF LINE-CONTACT CATT CYLINDER GEAR ON THE BENDING STRESS IN THE FILLETS
线接触圆弧齿线圆柱齿轮齿面接触变形对齿根应力的影响
3.
Adhesive elastic interaction of micro punch pre-contact
微冲头的微观粘附力及预接触变形分析
4.
An Analytical Method for Calculating of Hollow Cylindrical Roller Contact Deformation
空心圆柱滚子接触变形的一种计算方法
5.
Influences of bar/specimen contact surfaces' indentation on strain measurement in SHPB experiments
压杆/试样表面接触变形对SHPB实验应变测量的影响
6.
An Investigation on Material Micro-removal in Ultrasonic Gear Honing and Contact Analysis;
超声波平行轴硬珩齿微观切削过程的研究及其接触变形分析
7.
Comparison of Simulation Results of Local Contact Deformable Models on Multiple Elastic-plastic Impacts of Simply Supported Beam
局部接触变形模型对简支梁多次弹塑性撞击模拟结果的比较
8.
Studies on Deformation of Non-Contacting Gas-Lubricated Face Seal;
非接触式气体润滑机械密封变形研究
9.
Base on the elasticity contact and deformation theory, study the contact load and deformation of the pin and the link chain.
运用弹性接触和变形协调理论,研究销与接链环的接触受力及其形变。
10.
APPLYING VCL BACK-UP ROLL TORAISE THE CONTROL LEVEL OF STRIP SHAPE
应用变接触长度支承辊提高板形综合调控能力
11.
Axial load-deformation curve and preload on angular con act ball bearings
角接触球轴承的轴向载荷—变形曲线和预紧
12.
Study on Tool and Chip Contact Area DeformationTest for Martensite Ageing Steel Cutting
马氏体时效钢的刀-屑接触区变形试验研究
13.
Study on the change of the pattern visual evoked potential in work-ers exposed to lead
铅接触工人图形视诱发电位改变的研究
14.
A Contact Detection Method for the Three-dimensional Blocky System and Discontinuous Deformation Analysis (DDA);
三维块体系统接触检索算法与非连续变形分析
15.
NON-CONTACT MEASUREMENT TECHNIQUE FOR DYNAMIC RADIAL DEFORMATION OF EXPLOSION CONTAINMENT VESSELS
爆炸容器动态径向变形非接触测量技术
16.
Study on Shape Control Characteristics for Varying Contact Intermediate Roll of 6-hi Cold Rolling Mill
六辊冷轧机变接触中间辊板形控制性能研究
17.
Additionally, the stressand displacement of contact element are analysed, and the contact condition between“soft adapter” and rockfill dam are studied.
另外,还分析了接触单元的受力、变形情况,研究“软接头”与堆石坝之间的接触情况。
18.
The grain refinement begins from the center ellipsoidal zone, and then gradually expands to the vertical edge zone and conical contact zone.
细化首先开始于易变形区,再相继扩展到纵向棱边区和接触锥形区。