1.
3D ATOM PROBE CHARACTERAZATION OF ALLOY CARBIDES IN TEMPERING MARTENITEⅠ.Nucleation
回火马氏体中合金碳化物的3D原子探针表征 Ⅰ.形核
2.
3D ATOM PROBE CHARACTERAZATION OF ALLOY CARBIDES IN TEMPERING MARTENITEⅡ.Growth
回火马氏体中合金碳化物的3D原子探针表征 Ⅱ.长大
3.
3D ATOM PROBE CHARACTERAZATION OF ALLOY CARBIDES IN TEMPERING MARTENITEⅢ.Coarsening
回火马氏体中合金碳化物的3D原子探针表征 Ⅲ.粗化
4.
Tempering treatment resulted in formation of tempered martensite and the spalling resistance under repeated strong impact abrasion working conditions was largely improved.
在反复强力冲击工况条件下,回火得到回火马氏体,抗冲击剥落能力大为增加。
5.
Grain Boundary Martensite Formation and Tempering Brittleness at Low Temperature of Steels
钢的晶界马氏体形成与低温回火脆性
6.
martempering medium
马氏体分级淬火介质
7.
On Quasi austempering Bainitic/Martensitic Ductile Iron Grinding Ball
贝氏体/马氏体球铁磨球准等温淬火工艺的研究
8.
Research on Tempering Process in Granular Bainite Steel 25SiMoVB
粒状贝氏体钢25SiMoVB回火过程研究
9.
Microstructure and Properties of New Type Bainitic Steels at Low Temperature Tempering
低温回火态新型贝氏体钢的组织性能
10.
Preliminary Investigation on Austenitic Nitriding and Intermediate Temperature Tempering for 20Cr Steel
20Cr钢奥氏体渗氮中温回火的初步研究
11.
Study on Immediate Quenching Process of Martensitic Based Spheroidal Graphite Cast Iron Grinding Ball
马氏体基球墨铸铁磨球的余热淬火工艺分析
12.
Microstructure and Mechanical Properties of Cold-rolled Low-carbon Martensite after Annealing
冷轧低碳马氏体的退火组织及力学性能
13.
The Influence of Tempering Procedure on Mechanical Properties and Microstructures of Bainitic Rail Steel;
回火工艺对贝氏体轨钢组织性能的影响研究
14.
Effect of C and Si on the Toughness of Mn-Series Air Cooling Bainitic Steel After Tempering
碳和硅对Mn系空冷贝氏体钢回火韧性的影响
15.
Assessment of Recovery Characteristics Occurred in Cold Rolled Maraging Steel with X-Ray Diffraction Techniques
用X射线评价马氏体时效钢冷轧材的回复效应
16.
The content of thermalelastic martensite in the sample increases as the quenching temperature.
试样中热弹性马氏体含量随着淬火温度的升高而增多。
17.
As for small diameter workpiece, martensite distribution can be obtained by immediately quenching.
对于直径较细的工件，轧后立即淬火几乎可得到全部马氏体。
18.
Effect of long-term annealing on the martensitic transformation behavior of Ti-Ni-Cu alloy ribbons
长时间热退火对Ti-Ni-Cu合金条带马氏体相变行为的影响