1.
Fuzzy Controlling Interelectrode Gap Method of Electrochemical Machining(ECM) Based on 6-D Forces and Machining Current
六维力/加工电流模糊控制电解加工间隙的方法
2.
A STUDY ON THE GAP ELECTRICAL FIELD IN ECM BASED ON ELECTRODE PROCESSES
基于电化学过程的电解加工间隙电场的研究
3.
Study on the Detection & Controling of the LSWEDM Gap State Energy
慢走丝线切割加工间隙能量测量与控制的研究
4.
Gap Flow Research for Deep-Small Hole Drilling by EDM Based on Fluent Software
基于Fluent电火花深小孔加工间隙流场的研究
5.
On-line measuring interelectrode gap of processing blade based on information fusion
基于信息融合的叶片加工间隙在线检测方法
6.
Measurement and Control of Interelectrode Gap during Electrochemical Machining(ECM) Based on Wavelet Transform and Fuzzy Control
基于小波变换、模糊控制的电解加工间隙检测与控制
7.
The Preliminary Study of On-line Measuring the Gap in Electrochemical Machining Based on Analysis of Mechanical Test;
基于力学测试的电解加工间隙在线检测初步研究
8.
research of gap average voltage measuring method in micro-EDM
微细电火花加工间隙平均电压检测方法理论研究
9.
Research on Two-path Sampling Circuit of the EDM Gap Voltage and Relevant Fuzzy Control System
电火花加工间隙电压双路采集电路及其模糊控制系统的研究
10.
Influences on Ball Face NC Machining Accuracy of Transmission Clearance
传动间隙对球面数控加工精度的影响
11.
Analysis of Technological Characteristics for ECM with Fixed Gap in Intermittence Feed
定间隙间歇送进电解加工的工艺特性分析
12.
Technological Research on ECM with Mixed Gas and Fixed Gap and Interval Feed
混气-定间隙间歇进给电解加工技术研究
13.
impeller clearance
叶轮间隙;叶片间隙;导向叶片与工作叶片的间隙
14.
Study on volt-ampere properties in WEDM
电火花线切割加工中放电间隙伏安特性的研究
15.
Real-time Detection Method of Discharge Gap in WEDM Processing
电火花线切割加工中放电间隙状态的实时检测
16.
Efficiency of NC-electrochemical Contour Evolution Machining Based on Electrode Gap Characteristics
基于间隙特性的数控展成电解加工效率
17.
ECM with fixed gap in intermittent feed can be used as an effective means to improve the machining accuracy.
定间隙间歇送进电解加工是提高电解加工加工精度的一种有效方法。
18.
Implemented small gap for easy mounting. Roughness implemented and additional remark about surface finish.
为便于安装，**小间隙。**粗糙度和有关表面加工的附加备注。