1.
Development of Planar Flow Casting Atomization Process for Production of Sn-Cu Alloy Powders;
平面流铸雾化制取锡铜合金粉末的研究
2.
Application of the Method of the Mininum Zone of the Planoality on the Examine Cast Iron Planetable;
平面度最小区域法在铸铁平板检测中的应用
3.
A Study on Water Modeling of Fluid Flow in a Tundish for Horizontal Continuous Casting
水平连铸中间包内钢水流动的水模型研究
4.
Research of Surface Crack on Phosphor Bronze Strip Produced by Horizontal Continuous Casting
水平连铸锡磷青铜表面裂纹形成原因及探究
5.
Critical Gate Area of Mg Alloy in Counter-gravity EPC
镁合金反重力消失模铸造临界阻流面积的研究
6.
Study of Casting-Infiltration of Boron on Local Surface of Fluid-flow Components of Large Water Pumps;
大型水泵过流部件局部表面铸渗硼技术的研究
7.
Brilliant and Splendid,Founding and Meaningful--Writing Function of Spectacle in Prose;
流光溢彩 熔铸隽永——论场面在散文中的写作功能
8.
Water Modeling Study on Flow Field and Surface Wave in Slab Continuous Casting Mold
板坯连铸结晶器流场及液面波动水模研究
9.
Water Model of the Surface Wave and Fluid Flow in Slab Continuous Casting Mold
板坯连铸结晶器流场及液面波动的水模研究
10.
A case study on the lathe chuck plate casting has proved that the resulting flow pattern turns out to be the back drop along the back wall,occurring in a faster fashion.
对车床卡盘体铁铸件铸型进行充填说明流动形态沿型面背压上升比较快。
11.
Equilibrium Criterion and Application of Mass and Energy Transfer in Front of Metal Stream in EPC
消失模铸造液流前沿气隙中的质能传输平衡判据及应用
12.
Using Parallel Moving Method to Adjust the Signal of Eddy Current Sensor Measuring Internal-Combustion Engines Casting;
检测内燃机铸件的电涡流传感器输出信号的平移调整
13.
There easily exists shrinkage porosity due to superheat of ingate root in large plain parts investment casting.
大平面铸件常在内浇道根部出现过热,在该处产生缩松缺陷。
14.
Improvement of Surface Quality of Round Al Alloy Billets Cast by Semi-continuous Horizontal Process
铝及铝合金水平半连续铸造圆锭表面质量的改善
15.
Properties of Sand Filling and Compaction in Pattern Cavity of Horizontal Varied Section on EPC
消失模铸造水平变截面型腔干砂的充填紧实特性
16.
Research on Production Process and Design of Main Engine Equipment on Heavy and Medium Section Ductile Iron Casting;
大中断面球铁水平连铸设备主机设计及生产工艺研究
17.
Non-linear analysis on cast tubular T-joints loaded by out-plane bending
平面外弯矩作用下的T形铸钢节点承载力非线性分析
18.
Analysis and Improvement of the Surface Cracks of the Shell Mold of Investment Castings of Aero-Engine Guide Vane
燃气轮机导流板精铸件型壳面层裂纹分析及改进