1.
Two Ways of Calculating General Pulling Force of Tight Screw Bolt Linking with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力的两种计算方法
2.
Studies on the Ways of Calculating General Pulling Force of Tight Screw Bolt Lin king with Beforehand Light Strength and Work Pulling Force;
受预紧力和工作拉力的紧螺栓联接的总拉力计算方法研究
3.
Study on Calculation Method about the Critical Preload of Hydraulic Press with Combined Pre-Tight Structure
组合预紧结构液压机临界预紧力的计算方法研究
4.
Testing Method Research of Preloading on the Ball Bearing Used in Gyro Motor
陀螺仪马达轴承预紧力测试方法研究
5.
Research on the Pretightening Force of Mckibben Pneumatic Artificial Muscles
基于Mckibben气动人工肌肉预紧力的研究
6.
Influence of Bolt Pretightening Force to GIS Shell Flange Intensity
螺栓预紧力对GIS壳体法兰强度的影响
7.
The types and working principle of preload of the angular contact ball bearings are introduced, the selection rules of the preload and calculation method of determining preload force are given.
介绍角接触球轴承预紧的类型及工作原理,给出了预紧选择原则和确定预紧力的计算方法。
8.
Analysis of Preload, Stress, Rellability of Titanium Screw Joint Structure;
钛合金螺纹连接结构预紧力、应力、可靠性分析
9.
Measuring methods of pre-tightening force of loader driving bevel gear based on differential tightening
基于差速拧紧的装载机主动锥齿轮预紧力测量方法
10.
Application analysis on the controlling method of the Pre - tightening Force for screw connection structure;
螺纹联接件预紧力控制方法工程应用分析
11.
Analyze on bolt pre-tightening force control methods of Ba-Tong damper
八通缓冲器联接螺栓预紧力控制方法分析
12.
Analysis of the Deformation of Assembled Frames and the Pretension of Tension Bolts
组合机架的刚度分析和拉杆预紧力研究
13.
Impact of Bolting Pre-compression Factor Analysis and Determine
影响锚杆支护预紧力的因素分析与确定
14.
Design Methods for Pre-tightening Forces and Permitted External Forces Acted on a Bolted Joint Based on 3D FEM Computation;
基于有限元计算的螺栓接头预紧力和允许外力设计方法
15.
In tins paper, we give a method for determination of pretensioned tension on the driving steel-belt, in the meantime we give the calculating formula.
本文提出了钢带传动中确定钢带预紧力的方法,并给出了计算公式。
16.
The Optimization of the Autofrettage Pressure and the Fiber Thickness of the Fully-wrapped Composite Gas Cylinder;
全缠绕复合气瓶预紧压力和缠绕层厚度的优化
17.
STUDY ON THE PRE-STRAINED SIX DIMENSIONAL FORCE TRANSDUCER WITH STEWART PLATFORM STRUCTURE;
基于Stewart平台的预紧式六维力传感器研究
18.
Stress Analysis of Composite Laminate Connected by Preloaded Bolt
复合材料层合板预紧螺栓连接应力分析