1.
Finite Element Simulation of Internal Pressure of Backward-Extruding Containers and Optimization of Combined-Containers;
反挤压凹模内压力的有限元模拟及组合凹模优化
2.
Failure Analysis on Bulging Die of Stainless Steel Elbow with Solid Medium
不锈钢弯头软模胀形凹模的失效分析
3.
Model study on necking force for cartridge globular female die and parameter optimization
球形凹模缩口力模型研究与参数优化
4.
A modeling method for punches and dies of progressive die for motor core
电机铁芯级进模凸模与凹模建模方法研究
5.
The Numerical Simulation for Steady Temperature Fields in Cavity Die of Injection Mould in Cooling Processing;
注塑模凹模冷却过程稳态传热温度场数值模拟
6.
The structure and composition of work area of blanking lower die were discussed in this paper.
讨论了冲裁凹模工作部分的结构组成。
7.
An Analysis of Die Breakage Cause in WEDM
凹模在线切割过程中炸裂原因的分析
8.
NEW MEASURE ON BLANK SCRAP UPCOING THE PRINOIPLE AND NEW DIE DESIGN
废料上行新对策──原理与新凹模设计
9.
A Study on Optimal Design Method for the Die of Forward Heat Extrusion
正向热挤压凹模优化设计方法的研究
10.
The Theoretical and Experimental Research on Drawing Technology of Curved Die;
曲面凹模拉深工艺的理论与试验研究
11.
Finite Element Analysis of Forward Extrusion Cavity Die for Deep Hole and Thin Wall Shell
深孔薄壁件正挤压凹模的有限元分析
12.
Molding and NC Machining of the Concave Moulds for Telephone Receiver Based on MasterCAM
基于MasterCAM的电话听筒凹模数控加工
13.
The measure of improving life of die without die plate for the hole punching on steel pipe
钢管无凹模冲孔冲头寿命提高的措施
14.
Printing done with a plate bearing an image in intaglio.
凹版印刷用刻有凹版图形的模具印刷
15.
A groove down the side of a piece of type used to ensure that it is correctly placed.
凹纹沿着模板的一道凹线，用来保证正确的放置
16.
Realization of Bump Texture Based on Phong Lighting Model
基于Phong光照模型的凹凸纹理模拟
17.
Hydrocarbon migration and reservoir?forming modes in gentle slope belt of Zhanhua sag
沾化凹陷缓坡带油气运移及成藏模式
18.
Conduit Systems & Reservoir Controlled Model Searching in Dongying Depression;
东营凹陷输导体系及其控藏模式研究