1.
Application of Acceptance Check Limit--GB/T3177-1997Check Up the Measure of Lubricity Workpiece;
验收极限的应用——GB/T3177-1997《光滑工件尺寸的检验》
2.
To measure work-pieces, stop the planer first, and then clean off the cutting scrap of work-piece with brush.
测量工件尺寸时必须停车，工件上的切屑须用刷子扫。
3.
NOTICE: The dimensions shown on the attached dwgs for ball are the finished (after final machining) dimensions; your rough machined forging must guarantee these final dimensions.
注：附件球体图纸上的尺寸为机加工后的最终尺寸，你们的粗加工锻件必须保证这些最终尺寸。
4.
Dimensional tolerances for plastic engineering moulded plastic pats
GB/T14486-1993工程塑料模塑塑料件尺寸公差
5.
Measurement of Key Dimensions of Large-size and Thin-wall Pieces Based on Vision Inspection Technology;
大尺寸薄壁零件关键尺寸的视觉检测
6.
The Coordinate Dimensions Calculation and Analysis of Disc Type Component NC Machining
圆盘形零件数控加工的坐标尺寸计算及分析
7.
The Measurement of Industrial Components Shape and Dimension Based on Image Processing System;
基于图像处理的工业零件形状尺寸测量系统
8.
A Single Batch Processing Machine with Nonidentical Job Sizes and Precedence constraints;
工件有优先约束和尺寸的单机分批排序问题
9.
Research and Design of Automatic Drilling and Riveting Machine for Large Thin-wall Workpiece Assembly
大尺寸薄壁工件自动钻铆机结构的研究与设计
10.
The Research on Machine Vision Detection System of Industrial Components' Shape and Dimension
工业零件形状尺寸的机器视觉检测系统的研究
11.
An algorithm for on-line batch scheduling with nonidentical job sizes
工件有尺寸的单机批调度问题的在线算法
12.
Microstructures of large DSM11 castings processed by directional solidification techniques
定向凝固工艺下大尺寸DSM11铸件的显微组织
13.
Design and Implementation of Machine Vision Detection System for Elliptical Work-piece
椭圆工件机器视觉尺寸检测系统设计与实现
14.
They can be obtained in all the industrial sizes and their metric equivalents.
各种工业尺寸或公制尺寸的胸架都有。
15.
The outside micrometers with dial indicators are a high precision tool used to make the outside measurement of large-sized and medium-sized workpieces.
带表外径千分尺用于测量大中型工件外尺寸的高精度量具。
16.
modular and dimensional co-ordination concept
构件式组合及尺寸配合
17.
Dimensional tolerances for castings
GB/T6414-1986铸件尺寸公差
18.
Raw Casting basic dimensions, in.,Over,Up to & including
毛坯铸件基本尺寸,英寸,大于,至