1.
The Cell Padding value must be a positive integer or zero.
单元格填充值必须是正整数或零。
2.
0 - Clip (Default);1 - Isometric;2 - Stretch
-剪裁(默认值);1-等比填充;2-变比填充
3.
median pack-to-formaton grainsize ratio
充填砾石与地层砂粒度中值比
4.
pack-to-formation median grain size ratio
充填物与地层砂粒度中值比
5.
Fill factor must be between 0 (use default) and 100.
填充因子必须介于0（默认值）和100之间。
6.
Based on Equivalence Region with Same Attribute Tracing for filling Algorithm;
基于同属性等值区域追踪的填充算法
7.
Voronoi-based topological contour filling approach for environmental impact assessment
基于Voronoi图的环评等值线快速拓扑填充
8.
Color filling grammar of contour map based on OpenGL scanning conversion
基于OpenGL的等值线图填充算法
9.
Invalid fill factor value specified. The value should be between 0 to 100.
指定的填充因子值无效。该值应该在0到100之间。
10.
Invalid fill factor value specified. The value should be within 0 to 100.
指定的填充因子值无效。该值应在0到100之间。
11.
Returns the statistical variance for the population for all values in the given expression.
返回给定表达式中所有值填充的统计方差。
12.
The results and suggestions are valuable for filling in coal mines.
分析结果及建议对煤矿充填有一定的参考价值。
13.
Invalid index fill factor. Specify a value between 1 to 100.
索引填充因子无效。请指定1到100之间的值。
14.
Invalid index fill factor. You need to specify a value between 1 to 100.
无效索引填充因子。请指定1到100之间的值。
15.
Returns the statistical standard deviation for the population for all values in the given expression
返回给定表达式所有值填充的统计标准偏差
16.
Specifies the fill threshold in units of 32 bytes.
用于指定填充阀值的大小，以32字节为一个单位。
17.
Numerical Simulation, Optimization and Control of Filling Process in Injection Molding;
塑料注射成型充填过程的数值模拟、优化与控制
18.
Study with Numerical Simulation and Field Actual Measurement on Mining with Backstowing Roadway of Xingdong Mine;
邢东矿充填巷式开采数值模拟与现场实测研究